VIVOTEK IP3133 Manual De Usuario
- 7 -
www.vivotek.com
to next paragraph “Software installation”. If the Ethernet is not available, Network
Camera will switch to wireless LAN mode.
Camera will switch to wireless LAN mode.
To install in wireless LAN
If the Ethernet is not available while power on, the Network Camera will search for any
access point with the SSID “default”. Once any access point is found, the LED will turn
green to wait for installation. If the network environment cannot meet the default
settings, install Network Camera in Ethernet to proceed with wireless LAN configuration.
The Network Camera provides a general I/O terminal block with one digital input and one
relay switch for device control. Pin 1 and pin 2 can be connected to an external sensor
device and the state of voltage will be monitored from the initial state 'LOW'. The relay
switch of pin 3 and pin 4 can be used to turn on or off the external device.
access point with the SSID “default”. Once any access point is found, the LED will turn
green to wait for installation. If the network environment cannot meet the default
settings, install Network Camera in Ethernet to proceed with wireless LAN configuration.
The Network Camera provides a general I/O terminal block with one digital input and one
relay switch for device control. Pin 1 and pin 2 can be connected to an external sensor
device and the state of voltage will be monitored from the initial state 'LOW'. The relay
switch of pin 3 and pin 4 can be used to turn on or off the external device.
1 DI-
INPUT (Initial state of DI is low)
2 DI+
INPUT (Max. 50mA, 12VDC)
3 SW_COMMON
OUTPUT (open from SW_OPEN at initial state)
(close with SW_OPEN when set DO to ON)
4 SW_NOPEN
OUTPUT (Max. 1A, 24VDC or 0.5A, 125VAC
Consult with the dealer of the peripherals for correct installation.