RCA L37WD23 Manual De Usuario

To mount your TV to the wall you need to purchase a VESA wall 
mount.

For models L26WD22 and L26WD23, purchase a VESA 100 x 100, 
M4 screw.

For models L32WD22 and L32WD23, purchase a VESA 200 x 200, 
M6 screw.

For model L37WD23, purchase a VESA 400 x 400, M6 screw. 

The VESA number is the horizontal and vertical measurement of 
the mounting holes. For example, 100 x 100 means the mounting 
measurements are 100mm horizontally and 100mm vertically.

1.  If the base is attached, you need to remove it before attaching the 

wall mount.

A. Place the TV facedown on a surface that is soft, yet strong 

enough to hold the TV.

B. Use a screwdriver to remove the screws from the holes 

as shown in the picture to the left. Models L26WD23 and 
L32WD23 have seven screws; model L37WD23 has six screws. 
The models with different numbers of screws are located 
relatively in the same place as the picture shows.

  Models L26WD22 and L32WD22 have four screws on the 

bottom of the base as shown above in Attaching Your TV's 
Base. 

2.  Make sure all cables are already connected to the TV.

3.  Follow the directions included with the wall mount to mount the 

TV to the wall. 

Your TV comes shipped without the base attached so that you can 
choose to mount your TV either to its base or to a wall (wall mount 
sold separately). If you want to mount your TV to the wall, don’t 
attach the base and instead follow the Mounting Your TV to the Wall 
instructions below. 

1.  Locate the base. For models L26WD22 and L32WD22, locate the 

four screws. For models L26WD23, L32WD23, and L37WD23, 
locate the three screws. 

2.  Attach the screws to the bottom of the base as the pictures to the 

left show. 

 

For models L26WD23, L32WD23, and L37WD23, the screw holes 
underneath the TV match with the screw holes inside the base. 
Push down on the top of the TV until it clicks into the base. 

 

For models L26WD22 and L32WD22, the two screws go into each 
side of the base.