Hitachi CS 51EAP Manual De Usuario

English

Oiler port (Fig. 34)

Clean the chain oiler port (42) whenever possible.

Fig. 34

Guide bar (Fig. 35)

Before using the machine, clean the groove and

oiler port (43) in the bar with the special gauge

oﬀ ered as an optional accessory.

Fig. 35

Side case (Fig. 36)

Always keep the side case and drive area clean of

saw dust and debris. Periodically apply oil or grease

to this area to protect from corrosion as some trees

contain high levels of acid.

Fig. 36

Fuel fi lter (Fig. 37)

Remove the fuel fi lter from the fuel tank and

thoroughly wash it in solvent. After that, push the

fi lter into the tank completely.

Fig. 37

NOTE

the

fi lter is hard due to dust and dirt, replace it.

Chain oil fi lter (Fig. 38)

Remove the oil fi lter and thoroughly wash it in

solvent.

Fig. 38

Cleaning the cylinder fi ns (Fig. 39)

When wood chips are caught between cylinder fi ns

(44), the engine may overheat, resulting in lower

output. To avoid this, always keep cylinder fi ns and

fan case clean.

Fig. 39

Icing protection system (Fig. 40, 41)

This system is to protect carburetor from icing when

the unit is operated in winter time.

1. When you need icing system work, remove air

fi lter cover (41). Pull out the shutter (45) from

inside the air fi lter cover and reinstall it in winter

time position by turning half-way. (Fig. 40) This

will allow heated air to fl ow from cylinder side to

carburetor cabin through the opening (46).

Fig. 40

NOTE

When winter time has been over and carburetor

will not suﬀ er from icing, make sure that the

shutter is reinstalled in ordinary position (Fig. 41).

000Book_CS51EAP_US.indb 16

2012/03/19 16:33:46