Bush Hog 305 Manual De Usuario

8

Figure 2-3

H.  Hold  driveline  sections  parallel  to  each  other

and  check  for  minimum  6  inches  (15cm)  overlap.
Figure 2-4). If driveline has been marked for cutting,
overlap  will  be  the  distance  between  two  marks.  If
driveline has less than minimum overlap, do not use.
Contact authorized Bush Hog dealer.

NOTE

If  driveline  is  the  correct  length,  omit  the  following
steps “I” through “L” and proceed to step “M”.

I.  Clamp  driveline  in  a  well  padded  vice  to  pre-

vent  damage  to  the  shield.  Cut  off  shield  where
marked. (Figure 2-5)

Figure 2-4

Minimum Overlap

Figure 2-5

J. Using cut off section of shield as a guide, cut

shaft the same amount. (Figure 2-6)

Figure 2-6

K.  Repeat  steps  “I”  and  “J”  to  other  driveline

section.

L.  Deburr  ends  of  driveline  sections  and  clean

away all chips and filings. (Figure 2-7)

Figure 2-7

M.  Apply  multi-purpose  grease  to  inside  of  outer

(female)  driveline  section.  Assemble  driveline  and
install  on  tractor  and  cutter.  Pull  on  each  driveline
section to be sure yokes lock into place. Make certain
driveline shielding is in place and in good condition.

N. Adjust lower lift arm(s) to level cutter right to left.

Refer to tractor operator's manual for instructions.