Land Pride RCR1272 Manual De Usuario
15
Section 3: Adjustments
12/15/15
RCR1248, RCR1260 and RCR1272 Rotary Cutter 326-047M
Deck Leveling & Cutting Height
There are 4 primary adjustments that should be made
prior to actual field operations:
prior to actual field operations:
•
•
•
•
Proper adjustment of each of these items will provide for
higher efficiency, improved cutting performance, and
longer blade life. The following tools will be needed:
higher efficiency, improved cutting performance, and
longer blade life. The following tools will be needed:
•
Pliable tape measure
•
Spirit or carpenters level
•
Open end or hex end wrench or socket set
•
Protective gloves
!
WARNING
Deck Leveling Left to Right
Figure 3-1:
1.
1.
Locate tractor with Rotary Cutter on a flat, level
surface.
surface.
2.
Use tractor’s hydraulic 3-point control lever to lower
cutter until the tailwheel makes contact with the
ground surface.
cutter until the tailwheel makes contact with the
ground surface.
3.
Place a level on the front of the cutter deck as shown
in Figure 3-1. Manually adjust either one or both of
the tractor’s lower 3-point arms to level the deck from
left to right. Some tractors have only a single
adjusting arm.
in Figure 3-1. Manually adjust either one or both of
the tractor’s lower 3-point arms to level the deck from
left to right. Some tractors have only a single
adjusting arm.
Deck Leveling
Figure 3-1
Cutting Height Adjustment
Figure 3-2:
!
CAUTION
1.
Using tractor’s 3-point hydraulic control, raise or
lower the 3-point arms until the front of the deck is
slightly lower than the rear of the deck.
lower the 3-point arms until the front of the deck is
slightly lower than the rear of the deck.
30295
Level
Section 3: Adjustments
Cutting Height
Figure 3-2
Cutting Height
30296
Blade Tip
Blade Tip
This End Should Be
Slightly Higher Than
Cutting Height
Slightly Higher Than
Cutting Height