Euro-Pro EP366 Manual De Usuario

Plug into 120V outlet.
1. Hold the hand vacuum firmly with your hand on the Handle (4).
2. Push the On/Off Power Switch (2) to “On” position.
3. Start vacuuming.

In order to vacuum high, hard to reach places such as ceilings, curtains/drapes, etc., use 

the Convertible Brush and Bristle Brush (12 & 13) as follows:
1. Remove the Floor - to - Carpet attachment (15).
2. Insert the Convertible Brush (12).
3. If you need a brush action, slide on the Bristle Brush (13) onto the 

Convertible Brush (12).

4. When vacuuming drapes/curtains, we recommend adjusting the variable suction 

control (16A).

Slide

The Hand Vacuum is a very powerful unit.  Make sure that 

you hold it firmly, otherwise it can slip out of your hand

and cause injury.

1. Slide the narrow end of one of the extension tubes (14) into the wide end of the 

other extension tube.  

2. Slide the narrow end of the long extension tube inside the Floor-to-Carpet 

attachment (15).

3. Slide the wide end of the assembled extension tube (14) into the round end of the 

Curved Hose / Wand Extension (16).

4. Slide the narrow, oval side of the Curved Hose/Wand Extension (16) into  the 

suction hole (3) of the vacuum unit.

5. Attach the shoulder strap (5) to the vacuum unit and hang it from your shoulder.
6. You can now proceed to vacuum your carpet or hard floor.

Warning: Always unplug from electrical outlet before opening the Dust Cup 

(container) (10).

1. To open the Dust Cup (container) (10), push button (1) and pull out the Dust Cup 

(container ) (10),  (fig. 1).

2. Pull out the Dust Cup Filter (8), (fig. 2).

3. Empty the dust from the Dust Cup Filter (8).

4. Rinse the Dust Cup Filter (8) in cold water, and then wait until it dries completely 

before replacing it into the Dust Cup (container) (10).

5. Place the Dust Cup Filter (8) carefully into the Dust Cup (container) (10).

6. Attach the Dust Cup (container) (10) to the Hand Vacuum.

Please Note:

To vacuum wooden floors, press Floor-to-Carpet Lever (15A) down, to lower the bristles 

down.
To vacuum carpets, press Floor-to-Carpet Lever (15A) up, to raise the bristles up. Very flat 

carpets can sometimes be vacuumed with the bristles down.

Please Note:   If floor nozzle does not move easily, we suggest that you reduce 

suction power on the variable suction control (16A).

Fig. 1

Fig. 2

Please Note:

The Variable Suction Control (16A) will allow  you to adjust the amount of suction by sliding it 

up or down.

Note: Variable length can be obtained by using one, or both of the extension tubes.

The suction hole (3) must be open, free of any obstructions at 
all times.  Otherwise, the motor will overheat and could 
become damaged.