Weed Eater 960 73 00-27 Manual De Usuario

1.  Using the deflector guard as a template, hold deflector 

guard on the top of the deflector aligning edge with the 

holes with bottom of writing and angled end with the 

rear of the deflector as pictured.

2.  Mark locations of (4) holes and drill using supplied #7 

drill bit.

3.  Insert screws from bottom through deflector and guard, 

place washer and then acorn nut on top of guard.  

Tighten with a screw driver and 3/8 wrench.

1.  Raise and hold deflector and metal shield in upright 

position.

2.  Place slot in lower chute over mounting tab on mower 

and position lower chute over mower opening as 

shown.

3.  Hook rear latch into flange hole on back of mower.
4.  Hook front latch into tab hole on front of mower.