Chauvet 648 Manual De Usuario
Impulse™ 648 User Manual Rev. 6
Page 11 of 21
4.
O
PERATION
Control Panel
Operation
To access the control panel functions, use the four buttons located underneath the
display. Please refer to the Product Overview to see the button locations on the control
panel.
display. Please refer to the Product Overview to see the button locations on the control
panel.
Button
Function
<MENU>
Press to find an operation mode or to back out of the current menu
option
option
<UP>
Press to scroll up the list of options or to find a higher value
<DOWN>
Press to scroll down the list of options or to find a lower value
<ENTER>
Press to activate a menu option or a selected value
Menu Map
Mode
Programming Steps
Description
DMX Mode
512
d__1-d512 Selects the DMX starting address
Manual Control
U--
d__0-d100 Controls manual dimmer
S__0-S100 Controls manual strobe speed (0-30 Hz)
Sound-Active
SUND
Turns on Sound-Active mode
Configuration
(DMX)
Set the product in DMX mode to control with a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
Starting Address
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product’s channels.
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product’s channels.
The Impulse™ 648 uses up to 2 DMX channels in its 2-channel DMX mode, which
defines the highest configurable address to 511.
defines the highest configurable address to 511.
If you are not familiar with the DMX protocol, you may refer to the DMX Primer section in
the Technical Information chapter.
the Technical Information chapter.
To select the starting address, do the following:
1. Press <MENU> repeatedly until 512 shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select the starting address.
4. Press <ENTER>.