Harbor Freight Tools 36 Manual De Usuario

Descargar
Página de 8
Page 4
For technical questions, please call 1-800-444-3353.
Item 69644 
        
Specifications
Lamp
36 LED lamps with reflective intensifier
Battery Pack
3.2V, 600mAh, Li-ion
Solar Panel
4" x 3" Amorphous Silicon
Detects Motion
Up to 20'
Range of Motion Up to 120°
Delay Time
30 Seconds
Setup - Before use:
  Read the entiRe impORtant SaFetY inFORmatiOn section at the beginning of this 
manual including all text under subheadings therein before set up or use of this product.
note: For additional information regarding the parts listed in the following pages, 
refer to Parts List and Diagram on page 7.
installation
1.  Decide where you want to place the Lamp and 
the Solar Panel.  The Solar Panel is equipped 
with a 16 ft. connecting wire, so the Lamp and 
Solar Panel can be installed up to 16 ft. apart.  
Set the Solar panel in a location that receives full, 
direct sunlight, a minimum of eight hours a day. 
angle the solar panel slightly toward 
the south (northern hemisphere).
2.  Mount the Solar Panel:
a.  Place the Solar Panel in the desired location, 
adjusting the unit to best fit the surface. 
b.  Mark the hole locations of the Base, 
then set the Solar Panel aside.
c.  Check that the marked areas are clear of 
obstacles such as cables and electrical lines. 
Drill holes for the enclosed Screws 
and Anchor Sleeves.
d.  Insert the Anchor Sleeves then secure the 
Solar Panel in place with the Screws.
3.  Mount the Lamp:
a.  Locate the unit six to eight feet above ground 
on a solid surface capable of supporting the 
Lamp and secure enough so that it will not 
move when exposed to vibrations or wind.  
The unit must be high enough to allow for 
motion detection and light distribution. 
b.  Mark the hole locations of the 
Mounting Bracket, then set the Lamp aside.
c.  Check that the marked areas are clear of 
obstacles such as cables and electrical lines. 
Drill holes for the enclosed Screws 
and Anchor Sleeves.
d.  Insert the Anchor Sleeves then secure 
the Lamp in place with the screws.
4. 
Figure a 
Carefully route the Power Cord of the 
Solar Panel to the Lamp and plug it into 
the Outlet on the back of the Lamp.
initial Battery Charging
Before the Security Light can operate properly, 
the batteries need to be fully charged. 
To charge the batteries: 
1.  Turn OFF the Power Switch. 
The battery will recharge without turning on 
the light while the Power Switch is off.
2.  Allow the battery to charge for 8 hours of full sunlight.
Sa
Fet
Y
Ope
R
ati
O
n
m
aintenan
C
e
Setup