Harbor Freight Tools 97294 Manual De Usuario

Page 3

SKU 97294

Battery

One Ni-Cd, AA 1.2V, 600mAh

per Light (included)

When unpacking, check to make sure 

that the item is intact and undamaged.  If 

any parts are missing or broken, please call 

Harbor Freight Tools at the number shown 

on  the  cover  of  this  manual  as  soon  as 

possible.

note:  For additional information regarding 

the parts listed in the following pages, 

refer to the Assembly Diagram near 

the end of this manual.
Open the battery cover on the bottom 

of the unit to verify that battery 

polarity is correct.  Be careful not to 

pull on the wires connected to the 

cover, damaging the wires will render 

the unit dysfunctional.  If necessary, 

remove tabs between the battery and 

the post.  The battery must make 

contact with the post to operate.
Take an Inner Cover (2), place it over 

the light bulb and rotate it clockwise 

until the tabs on the Inner Cover are 

underneath the lip on the Cap.
Turn the Solar Light on.  

1.

2.

3.

Place an Outer Cover (3) over the 

Inner Cover and rotate it clockwise 

until the Tabs on the Outer Cover are 

underneath the lip on the Cap.  
Examine the area where the Solar 

Light is to be placed.  Make sure 

there are no utility lines beneath the 

surface that might be damaged.  For 

best results, the Lights should be 

placed in an area that receives at 

least eight hours of direct sunlight per 

day. 

Place a Spike (6) onto a Shaft (4) and 

push the unit firmly into the ground.  
The Solar Light can either be placed 

on the Shaft now, or a Connector (5) 

can be used to connect another Shaft  

and raise the height of the Light.  
Repeat these steps to assemble all 

the lights.  

4.

5.

6.

7.

8.