Snapper 285Z Manual De Usuario
27
Figure 25. Mower Leveling - Front-to-Back
A
B
B
C
C
A
Servicing the Mower Blades
1. Remove mower deck (see “Mower Deck Removal”).
2. See Figure 26. To remove blade for sharpening, use a
block of wood to prevent blade rotation while loosening
the hardware.
the hardware.
3. Remove the bolt (C, Figure 28), blade washer (B), and
blade.
4. Use a file to sharpen blade to a fine edge. If blade is
damaged, it must be replaced.
5. Balance the blade as shown in Figure 27. Center the
blade’s hole on a nail lubricated with a drop of oil. A
balanced blade will remain level.
balanced blade will remain level.
6. Reinstall the blade (Figure 28) with the tabs pointing up
toward the mower deck as shown.
7. Reinstall the blade washer (B, Figure 28), concave side
up, and bolt (C). Use a wooden block (A) to prevent blade
rotation while tightening the hardware. Torque hardware
to 50-60 ft-lbs (68-81 N.m.).
rotation while tightening the hardware. Torque hardware
to 50-60 ft-lbs (68-81 N.m.).
Figure 27. Balancing The Blade
Workbench
Nail
LOOSEN
Figure 26. Blade Removal
Figure 28. Blade Installation
WARNING
For your personal safety, blade mounting hardware must be
installed with the blade washer, then securely tightened to
50-60 ft-lbs (68-81 N.m.).
installed with the blade washer, then securely tightened to
50-60 ft-lbs (68-81 N.m.).
WARNING
For your personal safety, do not handle the sharp mower
blades with bare hands. Careless or improper handling of
blades may result in serious injury.
blades with bare hands. Careless or improper handling of
blades may result in serious injury.
Adjustments and Service
Not
for
Reproduction