Scag Power Equipment SW Manual De Usuario
12
Figure 9. Custom-Cut Baffle
2004 CCB
MOUNTING
HARDWARE
HARDWARE
MOUNTING
HARDWARE
HARDWARE
Hardware location used in the illustrations are for
reference only. Location of hardware may vary
depending on the cutter deck size.
reference only. Location of hardware may vary
depending on the cutter deck size.
-NOTE-
CUSTOM-CUT BAFFLE ADJUSTMENT
The Custom-Cut Baffle is designed to deliver optimum
airflow and superior cutting performance in any type of
grass. The Custom-Cut Baffle can be raised or lowered
to precisely tailor the deck's performance for the type of
grass being cut. The baffle can be set in three (3)
different positions for optimum performance.
airflow and superior cutting performance in any type of
grass. The Custom-Cut Baffle can be raised or lowered
to precisely tailor the deck's performance for the type of
grass being cut. The baffle can be set in three (3)
different positions for optimum performance.
TO ADJUST THE CUSTOM-CUT BAFFLE
A. 3" Position - baffle is installed using the top set of
holes on the front baffle welded inside the cutter
deck. (See Figure 10). The Advantage cutter deck
will deliver the best quality-of-cut in very tall, wiry,
tough to cut grass.
deck. (See Figure 10). The Advantage cutter deck
will deliver the best quality-of-cut in very tall, wiry,
tough to cut grass.
B. 3-1/2" Position (factory setting) - baffle is installed
using the middle set of holes on the front baffle
welded inside the cutter deck. (See Figure 11). For
general purpose cutting, place the Custom Cut Baffle
in the 3-1/2" position. This gives the best mix of
cutting performance in all types of grass.
welded inside the cutter deck. (See Figure 11). For
general purpose cutting, place the Custom Cut Baffle
in the 3-1/2" position. This gives the best mix of
cutting performance in all types of grass.
C. 4" Position - baffle is installed using the bottom set
of holes on the front baffle welded inside the cutter
deck. (See Figure 12). Placing the baffle in the 4"
setting will enhance fall cutting (leaf pickup) and
reduce cutter deck "blowout".
deck. (See Figure 12). Placing the baffle in the 4"
setting will enhance fall cutting (leaf pickup) and
reduce cutter deck "blowout".
HEIGHT:
1. Remove the hardware securing the Custom-Cut Baffle
to the cutter deck (See Figure 9).
Figure 12. 4" Custom-Cut Baffle Position
BOTTOM SET OF HOLES
FOR 4" SETTING
FOR 4" SETTING
2004 CCB - 4" Setting
CARRIAGE BOLT
ELASTIC STOP
NUT
NUT
2. Move the Custom-Cut Baffle to desired position. (See
Figures 10 through 12 for position)
3. Reinstall the mounting hardware as shown. (See Figures
10 though 12). Torque hardware to 39ft.lbs.
Figure 10. 3" Custom-Cut Baffle Position
Figure 11. 3-1/2" Custom-Cut Baffle Position
TOP SET OF HOLES
FOR 3" SETTING
FOR 3" SETTING
2004 CCB - 3" Setting
CARRIAGE BOLT
ELASTIC STOP
NUT
NUT
MIDDLE SET OF HOLES
FOR 3-1/2" SETTING
FOR 3-1/2" SETTING
2004 CCB - 3-1/2" Setting
CARRIAGE BOLT
ELASTIC STOP
NUT
NUT