Rhino Mounts SE8A Manual De Usuario
ASSEMBLY
SE8A 01/11
Assembly Section 3-10
© 2011 Alamo Group Inc.
ASSEMBL
Y
JACKSHAFT BEARING SUPPORT ASSEMBLY (PULL TYPE)
Attach the Jackshaft bearing support bracket (1) to the tongue. Loosely attach bearing support by using pivot
bolt (3) with bushing (6), flatwasher (7), and locknut (8) on each side. Install Bearing and housing assembly (4).
Install spacers (5), bolt (2), and locknut (9) leaving installed loosely. Tighten bolt (2) NOTE: Do not tighten to
point of collapsing spacer (5). Tighten pivot bolt (3)
bolt (3) with bushing (6), flatwasher (7), and locknut (8) on each side. Install Bearing and housing assembly (4).
Install spacers (5), bolt (2), and locknut (9) leaving installed loosely. Tighten bolt (2) NOTE: Do not tighten to
point of collapsing spacer (5). Tighten pivot bolt (3)
NOTE: Do not over tighten. Make sure Carrier Bearing (4) pivots in supports and complete assembly pivots on
lower bolts. Slide Jackshaft through bearing (4) on Jackshaft.
lower bolts. Slide Jackshaft through bearing (4) on Jackshaft.
CHECK TO BE SURE GEARBOX IS FILLED WITH LUBRICANT UP TO THE TEST PLUG LEVEL.
The lubricant required is Multi-purpose gear oil (P/N 00786250) for extreme pressure and temperature.
The Center Gearbox capacity is 2-1/2 quarts and the Outer Gearbox capacity is 1-3/4 quarts.