Poulan 224110X92E0 Manual De Usuario

Descargar
Página de 16
5
ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in 
its entirety before you attempt to assemble 
or operate your new lawn mower.  
IMPORTANT:  This lawn mower is shipped 
WITHOUT OIL OR GASOLINE in the engine.
Your new lawn mower has been as sem bled 
at the factory with the exception of those 
parts left unassembled for shipping purposes.  
All parts such as nuts, washers, bolts, etc., 
nec es sary to complete the as sem bly have 
been placed in the parts bag.  To ensure safe 
and proper operation of your lawn mower, all 
parts and hard ware you assemble must be 
tightened securely.  Use the correct tools as 
necessary to ensure proper tightness.  
TO REMOVE MOWER FROM CAR TON
1.    Remove loose parts included with mower.
2.   Cut down two end corners of  carton 
and lay end panel down fl at.
3.   Remove all packing materials except 
padding between upper and lower 
handle and padding holding operator 
presence control bar to upper handle.
4.   Roll lawn mower out of carton and 
check carton thor ough ly for additional 
loose parts. 
HOW TO SET UP YOUR MOW ER 
TO UNFOLD HANDLE
IMPORTANT
:  Unfold handle carefully so 
as not to pinch or damage con trol cables. 
TO INSTALL ATTACHMENTS 
Your lawn mower was shipped ready to be 
used as a mulcher.  To convert to dis-
charging, see “TO CON VERT MOW ER” in 
the Operation section of this man u al.
 Gasoline Capacity / Type:         1.0 Quarts (0,94 Litres) Unleaded Regular
 Oil Capacity:                             20 Ounces (0,58 Litres)
 Oil Type (API SG–SL):              SAE 30 (above 0°C/32°F); SAE 5W-30 (below 0°C/32°F)
 Spark Plug:                               Champion RJ19LM (Gap: 0.30" / 0,76 mm)
 Blade Bolt Torque:                    35-40 ft. lbs. (47-54 N-m)
  
PRODUCT SPECIFICATIONS
 WARNING: This lawn mower is equipped with an internal com bus tion engine and should 
not be used on or near any un im proved forest-covered, brush-covered or grass-cov ered 
land unless the engine’s exhaust system is equipped with a spark arrester meeting ap-
plicable local or state laws (if any).  If a spark arrester is used, it should be maintained 
in effective working order by the operator.  In the state of California the above is required 
by law (Section 4442 of the California Public Resources Code).  Other states may have 
similar laws.  Federal laws apply on federal lands.  A spark arrester for the muffl er is 
available through your nearest authorized service center.
MOWING 
POSITION
Lower handle
LIFT 
UP
Operator 
presence 
control bar
Upper 
handle
LIFT 
UP
Handle 
knob
1.   Raise handles until lower handle sec-
tion locks into place in mowing position.
2.   Remove protective padding, raise up-
per handle sec tion into place on lower 
handle and tighten both handle knobs.
3.    Remove handle padding holding operator 
pres ence control bar to upper handle.
Your lawn mower handle can be adjusted 
for your mowing comfort. Refer to “AD-
 JUST HANDLE” in the Service and Adjust-
ments section of this manual.
•   Never attempt to make wheel height 
adjustments while the engine is running.
•   Grass catcher components are sub ject to 
wear, dam age, and de te ri o ra tion, which 
could expose moving parts or allow objects 
to be thrown. Frequently check com po -
nents and replace with man 
u fac tur er’s 
recommended parts, when necessary.
•   Mower blades are sharp and can cut. 
Wrap the blade(s) or wear gloves, and 
use extra caution when ser vic ing them.
•   Do not change the engine governor set-
ting or overspeed the engine.
•   Maintain or replace safety and instruc-
tion labels, as necessary.