Exmark VT730EKC524 Manual De Usuario
Maintenance
Cleaning
Clean Engine and Exhaust
System Area
System Area
Service Interval: Before each use or daily
(May be required more
often in dry or dirty
conditions.)
often in dry or dirty
conditions.)
CAUTION
Excessive debris around engine cooling air
intake and exhaust system area can cause engine,
exhaust area, and hydraulic system to overheat
which can create a fire hazard.
intake and exhaust system area can cause engine,
exhaust area, and hydraulic system to overheat
which can create a fire hazard.
Clean all debris from engine and exhaust system
area.
area.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Clean all debris from rotating engine air intake
screen, around engine shrouding, and exhaust
system area.
system area.
3. Wipe up any excessive grease or oil around the
engine and exhaust system area.
4. Clean oil coolers (if equipped) of all debris, dirt,
and oil.
Remove Engine Shrouds and
Clean Cooling Fins
Clean Cooling Fins
Service Interval: Every 80 hours
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Remove cooling shrouds from engine and clean
cooling fins. Also clean dust, dirt, and oil from
external surfaces of engine which can cause
improper cooling.
external surfaces of engine which can cause
improper cooling.
3. Make sure cooling shrouds are properly reinstalled.
Operating the engine without cooling shrouds will
cause engine damage due to overheating.
cause engine damage due to overheating.
Clean Debris From Machine
Service Interval: Before each use or daily
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Clean off any oil, debris, or grass build-up on the
machine and cutting deck, especially under deck
belt shields, around the fuel tank, around engine
and exhaust area.
belt shields, around the fuel tank, around engine
and exhaust area.
Clean Grass Build-Up Under
Deck
Deck
Service Interval: Before each use or daily
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Raise deck to the transport (maximum cutting
height) position. Lift the front of unit and support
unit using jack stands or equivalent support.
unit using jack stands or equivalent support.
CAUTION
Raising the mower for service or maintenance
relying solely on mechanical or hydraulic
jacks could be dangerous. The mechanical or
hydraulic jacks may not be enough support
or may malfunction allowing the unit to fall,
which could cause injury.
relying solely on mechanical or hydraulic
jacks could be dangerous. The mechanical or
hydraulic jacks may not be enough support
or may malfunction allowing the unit to fall,
which could cause injury.
Do Not rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands
or equivalent support.
jacks for support. Use adequate jack stands
or equivalent support.
3. Clean out any grass build-up from underside of
deck and in discharge deflector.
Waste Disposal
Motor Oil Disposal
Engine oil and hydraulic oil are both pollutants to
the environment. Dispose of used oil at a certified
recycling center or according to your state and local
regulations.
the environment. Dispose of used oil at a certified
recycling center or according to your state and local
regulations.
45