John Deere L17.542 Manual De Usuario

Service Engine - 33

MX10526

4. Remove dipstick (A). Wipe with clean cloth.

5. Install dipstick.

•

Briggs and Stratton Engines: Install and tighten 

dipstick.

•

Kohler Engines: Install dipstick in tube, but do not 

tighten it. Let dipstick threads rest on top of tube, turn 
cap counterclockwise until it “clicks” or starts to engage 
threads.

6. Remove dipstick.

M88476

7. Check oil level on dipstick. Oil must be between ADD 
and FULL marks.

8. If oil level is low, add oil to bring oil level no higher than 
FULL mark on dipstick. Do not overfill.

9. Install and tighten dipstick. Lower hood.

1. Run engine to warm oil.

2. Park machine safely. (See Parking Safely in the 
SAFETY section.)

3. Lift hood.

4. Put drain pan under drain valve.

MX10525

5. Rotate and remove drain cap (B) and drain oil into oil 
drain pan. Allow oil to drain completely.

6. Remove dipstick (A).

7. Replace oil filter (C), if equipped.

a. Wipe dirt from around oil filter (C).

b. Place a drain pan or funnel under filter tray.

c. Remove old filter and wipe off filter tray.

d. Put a light coat of fresh, clean oil on the filter gasket.

e. Install replacement oil filter by turning oil filter to the 
right (clockwise) until the rubber gasket contacts filter 
base. Tighten filter an additional one-half turn.

8. Install drain cap.

9. Add oil no higher than FULL mark on dipstick. Use 
approximately the amount of oil listed below. Do not overfill.

10.Install dipstick.