Husqvarna ProFlex 21 Manual De Usuario

English-

83

1.

Delivery Service

2.

Fill the battery with battery acid and charge for four hours.

3.

Fit the steering wheel, seat and, where applicable, other 
components.

4.

Attach the cutting unit.

5.

Adjust the cutting unit:

Adjust the lifting springs (the “weight” of the cutting unit should 
be 12-15 kg, if a brush is to be used, set to maximum spring 
force).

Adjust the cutting unit so that its rear edge is about 2-4 mm 
higher than its front edge.

Adjust the cutting unit’s cutting height setting so that the 
cutting height limit is 5 mm above the unit frame at the lowest 
cutting height.

Check that the right amount of oil is in the engine and 
transmission.

6.

Check and adjust the air pressure in the tyres (60 kPa, 0.6 bar).

7.

Connect the battery.

8.

Fill the fuel tank and start the engine.

9.

Check that the machine does not move in neutral.

10. Check:

Driving forwards.

Reversing.

Engaging the blades.

Safety switch in the seat.

Safety switch for the lifting lever.

The safety switch for the hydrostat pedals.

11. Check the engine speed: 3,000 ±75 rpm.

12. Bleed the hydraulic system (PF 21).

13. Inform the customer about:

14. The need and advantages of following the service schedule.

15. The need and advantages of leaving the machine for service 

every 300 hours.

16. The effects of service and maintaining a service journal on the 

machine’s resale value.

17. Application areas for Mulching.

18. Fill in the sales papers, etc.

1.

Change engine oil.

Delivery service has been 
carried out.

No remaining remarks.

Certified: