Husqvarna LZF6127 Manual De Usuario

LUBRICATION

English

-51

If possible, grease both ends of the cables and move the controls to end stop positions when lubricating. Refit the 

rubber covers on the cables after lubrication. Cables with sheaths will bind if they are not lubricated regularly. If a 

cable binds, it can disrupt operation.
If a cable binds, remove the cable and hang it vertically. Lubricate it with light engine oil until the oil begins to 

escape from the bottom. 
Tip: Fill a small plastic bag with oil and tape it so that it seals against the sheath and allow the cable to hang 

vertically from the bag overnight. If you do not succeed in lubricating the cable, it must be replaced.

8011-565

8011-571

Lubricate the bearing of the shafts and linkage for 

brake system and steering with oil spray or oil can.

Hydraulic System, Oil Level
The hydraulic oil and filter must be replaced every 300 

hours, and at least once a year. Contact an authorized 

service workshop.
Check the oil level in the hydraulic tank daily. The level 

shall be about ¾"-1" (19 - 25 mm) below the top of the 

tank.
Check connections, hoses, and tubes for damage or 

leaks. Replace or repair if doubtful.
Changing Oil and Filters
Oil and filter changes for the hydraulic system should 

be carried out by an authorized service workshop due 

to the risk of impurities enter the system.

Driver’s Seat
Tip the seat.
Lubricate the front hinges using an oil can.
Lubricate the lengthways adjustment mechanism with 

the oil can.
Lubricate the lengthways adjustment runners with the 

oil can.