Cub Cadet SC2400 Manual De Usuario

Descargar
Página de 133
Sc2400 Operator’s Manual
NOTE:
●While turning the key to the preheating position, the 
preheater pilot light turns ON. Also, the engine oil 
pressure warning light and the alternator / battery 
charging light turn ON.
(A) Preheater pilot light
12.Turn and hold the key to the START 
position. After the engine is 
successfully started, release the key.
IMPORTANT: Avoid starter damage.
●Do not hold the key in the START position for more 
than 15 seconds at a time. Any longer attempt will 
overheat the starter motor.
●If the engine is difficult to start at a low temperature 
etc., hold the key in the START position for 30 
seconds. If the engine fails to start, wait at least 30 
seconds before the second attempt to allow for 
battery voltage recovery.
●If the engine still fails to start with four consecutive 
attempts, the starter may be not functioning. (See 
“17. TROUBLESHOOTING” ).
13.After the engine has started, warm up 
the engine for 5 minutes at 2000 to 
2400 rpm without loading.
■ Warming Up the Engine in Cold Weather
In cold weather, warm up the engine for much longer 
than 5 minutes so that the hydraulic system shows its 
performance. For the appropriate warming up time, 
refer to the table below.
NOTE:
●The engine may run slightly louder and emit pale 
blue exhaust during warming-up. This is considered 
normal operation. The amount of pale blue exhaust 
varies depending on the ambient temperature.
●Idling the engine for a long time causes waste of 
fuel and carbon accumulation in the engine. 
Temperature (°F (°C))
Warming-up Time (min.)
Over 32 (0)
At least 5
32 to 14 (0 to –10)
5 to 10
14 to –4 (–10 to –20)
10 to 15
Below –4 (–20)
More than 15
3014905
(A)