Cub Cadet SC2400 Manual De Usuario

■ Changing the Engine Oil

For the maintenance work, see “Engine Oil” on page 14-23.

■ Replacing the Engine Oil Filter

For the maintenance work, see “Replacing the Engine Oil Filter” on page 14-27.

■ Changing the Transmission Oil

For the maintenance work, see “Changing the Transmission Oil and Replacing the Transmission Oil Filter” on 
page 14-29.

■ Replacing the Transmission Oil Filter

For the maintenance work, see “Changing the Transmission Oil and Replacing the Transmission Oil Filter” on 
page 14-29.

■ Checking the Front Axle Oil Level

IMPORTANT: Avoid damage.
●Before checking the oil level, allow the oil to settle 

for 1 hour so that the current oil level can be 
accurately read on the dipstick. Recheck the oil 
level after operating the tractor for several hours.

1. Park the tractor safely and securely.
2. Allow the tractor to cool off for at least 1 hour and 

the oil to settle.

IMPORTANT: Avoid damage. 
●Dirt and debris in the oil may damage the front 

axle. Clean the area around the dipstick before 
removing it.

3. Loosen and remove the dipstick situated on the 

right side of the front axle.

4. Wipe the dipstick clean with a rag. Only insert the 

dipstick into the hole on axle. At this point, do not 
fasten the dipstick into the axle case.

5. Remove the dipstick again. Read the oil level on 

the dipstick. The oil level should be between the 
high and low level marks on the dipstick.

• Add Cub Cadet GEAR LUBE or SAE 80W-90 

gear oil through the fill opening until the oil level 
is appropriate.

• Reinstall and tighten the dipstick.

6. Operate the tractor for several hours, and then 

check the front axle oil level again.

P3014922

High

Low

3013741

3014928