Cub Cadet 769-05905 Manual De Usuario

Descargar
Página de 40
Service
7
26
WARNING! 
Before performing any service, place 
the PTO switch in the “OFF” position, engage the 
parking brake lever, turn the ignition key to the 
“OFF” position and remove the key from the switch.
Battery Removal
WARNING! 
Battery posts, terminals and related 
accessories contain lead and lead compounds. Wash 
hands after handling.
The battery is located beneath the seat box frame. To remove the 
battery:
Push down and back on the battery hold-down bracket as 
1. 
shown in Fig. 7-1 to free it from the seat mount frame.
Remove the hex cap screw and sems nut securing the black 
2. 
negative battery lead to the negative battery post (marked 
NEG). Move the cable away from the negative battery post.
Remove the hex cap screw and sems nut securing the red 
3. 
positive battery lead to the positive battery post (marked 
POS).
Carefully lift the battery out of the tractor.
4. 
Install the battery by repeating the above steps in the 
5. 
reverse order. 
WARNING! 
Always connect the positive lead to the 
battery before connecting the negative lead. This 
will prevent sparking or possible injury from an 
electrical short caused by contacting the tractor 
body with tools being used to connect the cables.
Charging the Battery
Test and, if necessary, recharge the battery after the tractor has 
been stored for a period of time.
A voltmeter or load tester should read 12.6 volts (DC) or 
• 
higher across the battery terminals. See Fig. 7-2.
Charge the battery with a 12-volt battery charger at a 
• 
MAXIMUM rate of 10 amps.
Servicing Electrical System
A fuse is installed to protect the tractor’s electrical system from 
damage caused by excessive amperage. Always use the same 
capacity fuse for replacement. If the electrical system does not 
function, check for a blown fuse.
If you have a recurring problem with blown fuses, have the 
tractor’s electrical system checked by your Cub Cadet Service 
Dealer.
Relays and Switches
There are several safety switches in the electrical system. If a 
function of the safety interlock system described earlier is not 
functioning properly, have the electrical system checked by your 
Cub Cadet Service Dealer.
Voltmeter  
Reading
State of  
Charge
Charging  
Time
12.7
100%
Full Charge
12.4
75%
90 Min.
12.2
50%
180 Min.
12.0
25%
280 Min.
Figure 7-1
Figure 7-2