Cub Cadet 769-05905 Manual De Usuario

One Lawn Tractor

• 

One Oil Drain Hose

• 

One Deck Wash Hose Coupler 

• 

One Z-Force S  Tractor Operator’s 

• 

Manual

One Engine Operator’s Manual

• 

LPG Tank Strap Assemblies

• 

One Hardware Pack

• 

Remove the upper crating material from the shipping pallet, 

1. 

and cut any bands or tie straps securing the tractor to the 

pallet. 
If the deck is not in the highest mowing position (pushed all 

2. 

the way forward), use the deck lift pedal to raise the deck to 

its highest position. Refer to the Controls & Features section 

for instructions on raising and lowering the deck.
Disengage the parking brake.

3. 

Engage the transmission bypass rods on each side of the 

4. 

tractor; then carefully roll the tractor off the shipping pallet. 

The transmission bypass rods (one for each the RH and LH 

transmission) are located on the rear of the tractor, just 

inside each rear wheel. Disengage the bypass rods.  See Fig. 

3-1.

Remove the deck wash system nozzle adapter and oil drain 

5. 

tube from the manual bag and store for future use. 

NOTE: The vapor withdrawal service valve of the Aluminum 

Outdoor Equipment Propane Cylinder is fitted with left-hand 

threaded safety coupler. Typical forklift cylinders withdraw liquid 

propane and have right-handed safety couplers. The different 

safety couplers prevent users from installing cylinders on the 

wrong equipment.
The LPG tank is shipped separately and will need to be purged 

before the initial fill-up. 
It is important to properly purge new propane cylinders before 

the first fill. The authorized LP-Gas filler should follow proper 

purge guidelines outlined in NPGA Bulletin #133.89(a).
Once properly purged, fill the cylinder through the fill valve with 

Overfill Prevention Device (OPD) in accordance with section 7.4 

of the Liquefied Petroleum Gas Code, NFPA 58-2008.

The tank straps need to be installed before the tank can be 

installed. To install the tank proceed as follows:

Remove the strap assemblies, alignment pin and two bolts 

1. 

from the box. Then remove the four hex screws and flange 

lock nuts from the manual bag.
Mount the alignment pin to the strap assembly using the 

2. 

two bolts. See Fig. 3-2. Then using the hex screws and 

flange lock nuts mount the strap assemblies to the mount 

plate as shown in Fig. 3-2.