Cisco Systems MEM-C6K-FLC16M Manual De Usuario
3
Catalyst 6500 Series Supervisor Engine Flash PC Card Installation Note
78-6507-06
Preventing Electrostatic Discharge Damage
Figure 1
Supervisor Engine Flash PC Card Slot
For information about using the PCMCIA Flash PC cards, see the
Preventing Electrostatic Discharge Damage
Follow these guidelines to prevent electrostatic discharge (ESD) damage:
•
Always use an ESD wrist or ankle strap, and ensure that it makes good skin contact.
•
Connect the equipment end of the strap to the ESD connector on the switch.
•
Place a removed Flash PC card on an antistatic surface or in a static shielding bag. If the card will
be returned to the factory, immediately place it in a static shielding bag.
be returned to the factory, immediately place it in a static shielding bag.
•
Avoid contact between the card and clothing. The wrist strap only protects the card from ESD
voltages on the body; ESD voltages on clothing can still cause damage.
voltages on the body; ESD voltages on clothing can still cause damage.
Caution
For safety, periodically check the resistance value of the antistatic strap. The measurement should be
between 1 and 10 megohms.
between 1 and 10 megohms.
Installing and Removing a Flash PC Card
Before you install a Flash PC card, verify that the card’s write-protect switch is off. When the card is
oriented with the printing side up and the edge connector end away from you, the write-protect switch
is located on the front edge of the card, as shown in
oriented with the printing side up and the edge connector end away from you, the write-protect switch
is located on the front edge of the card, as shown in
.
Note
Not all Flash PC cards have the write-protect switch.
16057
SUPERVISOR I
WS-X6K-SUP1
STATUS SYSTEMACTIVE PWR MGMT
RESET
CONSOLE
Switch Load
100%
1%
CONSOLE
PORT
MODE
PORT
MODE
PCMCIA
EJECT
PORT 1
LINK
PORT 2
LINK
PCMCIA LED
LINK LEDs
Switch load
display
Status LEDs
RESET button
CONSOLE port
CONSOLE PORT MODE
switch
PCMCIA slot
1000BASE-X GBIC Uplink Ports