3M 2273ME Manual De Usuario
78-8130-6151-8-E
31
5. Adjust the Gain Down [4] until the bar graphs open.
− The bar graph will close, the audio will increase, and the signal strength will be
maximum when the receiver detects a marker of the specified utility.
− When one of the two markers is detected, press the “XXX Only” [SK] for the
detected utility marker.
− The unit will switch to Single Marker Locate in order to pinpoint the marker.
6. Press Markr 2 [SK Toggle] to return to Dual Marker Locate.
Marker Depth Estimate
ID Marker Depth
1. Lower the tip of the receiver to the ground over the targeted marker.
2. Press Depth [SK].
− The receiver will examine the marker
(Calculating, please wait...)
− If the marker is a 3M
™
Dynatel
™
iD
Marker, the receiver will display the
depth of the marker, and its identification
number.
depth of the marker, and its identification
number.
3. To save the depth reading, press Mem Select
[SK].
− Five depth readings can be saved with the
time, date, and its identification number.
− Save [SK] will place each entry in
sequential order in memory (M1 - M5)
until five readings have been stored. The
unit will overwrite saved entries in excess
of five, beginning with M1.
until five readings have been stored. The
unit will overwrite saved entries in excess
of five, beginning with M1.
4. Press Clear All [SK] to delete all stored depth information.
5. Press Mem Select [SK] to select the memory location to store the depth readings.
When the preferred location appears on the screen, press Save [SK]. The screen and
memory location will populate with the current information.
memory location will populate with the current information.
6. Each memory location can be reviewed by pressing Mem Select [SK].
7. Press Locate [5] to return to Marker Locate Mode.