Dixon 3301 Manual De Usuario

 

To engage the mower blades, turn lever on floor slowly to the "ON" position. To 

disengage mower blades, turn lever slowly to the "OFF" position.

 

 

IMPORTANT - PERFORM SAFETY CHECKS AFTER MAKING ANY REPAIRS OR ADJUSTMENTS

 

1.   After reassembly, while seated on mower, attempt to start engine with mower deck engaged. 

Engine should not start. If engine does start, return the mower to an Authorized Dixon dealer for 
adjustment or repair.

 

2.  Disengage mower deck and start engine. With the operator in the normal seated position, 

engage mower deck and remove weight from seat. The engine should stop. If the engine does 
not stop when operator  rises from seat, return the mower to an Authorized Dixon dealer for 
adjustment or repair.

 

3.  Engage, then disengage mower blade in each cutting height. Insure that blade disengages 

and comes to a stop within (5) seconds in each height position. If blade  does nof disengage 
properly, contact your Authorized Dixon dealer.

 

 

 

1.   Raise upper body to the open position.

 

2.   Tighten nut on brake rod P/N 2533 located in front of the transaxle on each side, just enough to 

prevent brake from slipping when engaged.

 

CAUTION: Over tightening may cause premature wear on the brake band P/N 5085.

 

Revised 7/93 P/N 
8112

 

Page 3 of 8