American Standard 2901E SERIES Manual De Usuario

752867-100 Rev.D

(2)

INSTALLATION AND FRAMING INSTRUCTIONS
The variety of installations possible for this whirlpool may require framing procedures other than those shown.  Locate studs 
as required.  Ensure roughing-in dimensions are proper, plumb and square.  Provisions must be made in all installations for an 
access opening for servicing the pump and controls.  It is strongly recommended that an additional opening be provided for 
access to the drain components.

1. Position the whirlpool into the installation opening and level the deck, shimming the integral support feet as necessary. 

2. Install drain components to the whirlpool following the manufacturers instructions.  Before replacing your whirlpool for final 

installation, be certain that an opening has been provided in the sub-floor for the drain.  See the roughing-in drawing for 
suggested opening size and location dimensions.

3 . Replace whirlpool and re-shim the integral support feet, shimming the entire length of the support feet.  Secure the shims 

using construction adhesive, silicone, mortar or equivalent materials.  While not a necessity, the use of a foundation base 
consisting of cement (e.g. Sakrete), mortar, or grout will help provide a solid and secure installation.

LEVELING SURFACE

WATERPROOF
 SEALANT

BATH

A S   D E S I R E D

42"

(1067mm)

CUTOUT

A S   D E S I R E D

69-3/4"

(1772mm)

CUTOUT

20

(508mm)

ACCESS PANEL

2 4

( 6 1 0 m m )

12

(305mm)