DeWALT A16505 Manual De Usuario

lis

1. Pull quick-connect coupler back and insert

nozzle.

. Release quick-connect coupler and

twist nozzle to make sure it is secure in

coupler.

WARNING: Flying object could cause risk

of serious injury. Ensure nozzle is completely

inserted in quick-connect socket and quick-

connect snap ring is fully engaged (forward)

before squeezing gun trigger.

chemicals and cleaning Solvents

Applying chemicals or cleaning solvents is a low-pressure operation.
note: Use only soaps and chemicals designed for pressure washer

use.

Do not use bleach.

to aPPLY cHeMIcaLs anD soLVents
1. Press chemical hose (S) onto barbed

fitting located near high pressure hose

connection of pump as shown.

. Place the other end of chemical hose

with filter on it into the container holding

chemical/cleaning solution.

note: For every 7 gallons of water

pumped 1 gallon of chemical/cleaning solution will be used.

3. Install low-pressure (black) nozzle into quick connect fitting of spray

wand, refer

spray Wand nozzles.

4. After use of chemicals, place chemical hose into container of clean

water and draw clean water through chemical injection system

to rinse system thoroughly. If chemicals remain in the pump it

could be damaged. Pumps damaged due to chemicals will not be

covered under warranty.

note: Chemicals and soaps will not siphon when spray wand is in the

high-pressure setting.

Starting

WARNING: To reduce the risk of injury, read the pressure washer

instruction manual and the engine instruction manual before starting

pressure washer.

DANGeR: Risk of fluid injection and laceration. When using the high-

pressure setting,

Do Not allow the high-pressure spray to come in

contact with unprotected skin, eyes, or with any pets or animals. Serious

injury will occur.

• Your washer operates at fluid pressures and velocities high

enough to penetrate human and animal flesh, which could result

in amputation or other serious injury. Leaks caused by loose fit-

tings or worn or damaged hoses can result in injection injuries.

DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a

physician immediately!

WARNING: Risk of fire, asphyxiation and burning. NEvER fill fuel tank

when engine is running or hot. Do not smoke when filling fuel tank.

• NEvER fill fuel tank completely. Fill tank to 1/2" (12.7 mm) below

bottom of filler neck to provide space for fuel expansion. Wipe any

fuel spillage from engine and equipment before starting engine.

• NEvER run engine indoors or in enclosed, poorly ventilated

areas. Engine exhaust contains carbon monoxide, an odorless

and deadly gas.

• DO NOT let hoses come in contact with very hot engine

muffler during or immediately after use of your pressure

washer. Damage to hoses from contact with hot engine

surfaces will NOT be covered by warranty.

cAutIoN: NEvER pull water supply hose to move pressure washer.

This could damage hose and/or pump inlet.

• DO NOT use hot water, use cold water only.