Kärcher K 3.96 M Manual De Usuario
English
5
electrician or service personnel if you
are in doubt as to whether the outlet is
properly grounded. Do not modify the
plug provided with the product - if it will
not fit the outlet, have a proper outlet in-
stalled by a qualified electrician. Do not
use any type of adapter with this prod-
uct.
are in doubt as to whether the outlet is
properly grounded. Do not modify the
plug provided with the product - if it will
not fit the outlet, have a proper outlet in-
stalled by a qualified electrician. Do not
use any type of adapter with this prod-
uct.
Use only 3-wire extention cords that
have 3-prong grounding-type plugs
and 3-pole cord connectors that ac-
cept the plug from the product.
Up to 25 ft = 12/3 AWG;
25 to 50 ft = 10/3 AWG.
have 3-prong grounding-type plugs
and 3-pole cord connectors that ac-
cept the plug from the product.
Up to 25 ft = 12/3 AWG;
25 to 50 ft = 10/3 AWG.
Use only extension cords that are in-
tended for outdoor use. These ex-
tension cords are identified by the
marking “Acceptable for use with
outdoor appliances; store indoors
while not in use.”
tended for outdoor use. These ex-
tension cords are identified by the
marking “Acceptable for use with
outdoor appliances; store indoors
while not in use.”
Use only extension cords having an
electrical rating not less than the rat-
ing of the product.
electrical rating not less than the rat-
ing of the product.
Do not use damaged extension
cords.
cords.
Examine extension cord before us-
ing and replace if damaged.
ing and replace if damaged.
Do not abuse extension cord and do
not yank on any cord to disconnect.
not yank on any cord to disconnect.
Keep cord away from heat and sharp
edges.
edges.
Always disconnect the extension
cord from the receptacle before dis-
connecting the product from the ex-
tension cord.
cord from the receptacle before dis-
connecting the product from the ex-
tension cord.
If you are using an extension cord, it
should always be completely un-
wound from the cable drum.
should always be completely un-
wound from the cable drum.
WARNING
To reduce the risc of electrocution, keep
all connections dry and off the ground.
Do not touch plug with wet hands.
all connections dry and off the ground.
Do not touch plug with wet hands.
CAUTION
Dirt in the feed water will damage the
unit. To avoid this risk, we recommend
fitting a water filter.
unit. To avoid this risk, we recommend
fitting a water filter.
Water hose must be at least 1/2 inch
or 5/8 inch in diameter.
or 5/8 inch in diameter.
Flow rate of water supply must not
fall below 2 GPM (gallons per
minute).
fall below 2 GPM (gallons per
minute).
Flow rate can be determined by run-
ning the water for one minute into an
empty 5-gallon container.
ning the water for one minute into an
empty 5-gallon container.
The water supply temperature must
not exceed 104°F/40°C.
not exceed 104°F/40°C.
Never use the pressure washer to
draw in water contaminated with sol-
vents, e.g. paint thinners, gasoline,
oil, etc.
draw in water contaminated with sol-
vents, e.g. paint thinners, gasoline,
oil, etc.
Always prevent debris from being
drawn into the unit by using a clean
water source.
drawn into the unit by using a clean
water source.
SAVE THESE
INSTRUCTIONS !
Extension Cords
WATER SUPPLY (Cold Water
Only)