Homelite HL80833 Manual De Usuario

Descargar
Página de 52
10 — English
wARNiNg:
Do not allow familiarity with the product to make you care-
less. Remember that a careless fraction of a second is 
sufficient to inflict serious injury.
wARNiNg:
Always wear eye protection with side shields marked to 
comply with ANSI z87.1. Failure to do so could result in 
objects being thrown into your eyes resulting in possible 
serious injury.
wARNiNg:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of  
attachments or accessories not recommended can result 
in serious personal injury.
wARNiNg:
Never direct a water stream toward people or pets, or 
any electrical device. Failure to heed this warning could 
result in serious injury.
APPLicATiONS
You may use this product for the purposes listed below:
  Using  surface  cleaner:  removing  dirt  and  mold  from 
decks and cement patios
  Using spray wand: cleaning boats, motorcycles, outdoor 
furniture, grills, and house siding
AddiNg LUBRicANT TO ThE ENgiNE
See Figure 15.
NOTE: This machine has been shipped with approximately 
2 oz. of lubricant in the engine from testing. 
you must add 
lubricant to the engine before starting it the first time.
cAUTiON:
Any attempt to start the engine without adding lubricant 
will result in engine failure not covered under warranty.
  Place pressure washer on a flat, level surface.
  Unscrew  the  oil  cap / dipstick  by  turning  counter- 
clockwise.
  Using  4-stroke  engine  lubricant  (SAE  10W30),  add  
engine oil until the fluid level rises to the upper fill level on 
the dipstick (18 oz., 4-cycle engine lubricant provided).
 
do not overfill.
  Replace the oil cap / dipstick and securely tighten.
NOTE: This engine has a total lubricant capacity of 20 oz.  
(.6 liters).
OXygENATEd FUELS
dO  NOT  USE  E85  FUEL.  iT  wiLL  vOid  yOUR  wAR-
RANTy.
NOTE:
 Fuel system damage or performance problems re-
sulting from the use of an oxygenated fuel containing more 
than the percentages of oxygenates stated below 
are not 
covered under warranty.
Ethanol. 
Gasoline containing up to 10% ethanol by volume 
(commonly referred to as E10) or 15% ethanol by volume 
(commonly referred to as E15) are acceptable. E85 is not.
AddiNg gASOLiNE TO ThE FUEL TANK
See Figure 16.
wARNiNg:
Always shut off engine before fueling. Never add fuel to 
a machine with a running or hot engine. Move at least 
30 ft. from refueling site before starting engine. Do not 
smoke! Failure to heed this warning could result in seri-
ous personal injury.
When adding gas to the pressure washer, make sure the unit 
is sitting on a flat, level surface. If the engine is hot, let the 
pressure washer cool before adding gas. ALWAYS fill the 
fuel tank outdoors with the machine turned off.
NOTE: Use unleaded gas only. DO NOT mix lubricant with 
gas.
  Before removing the fuel cap, clean the area around it. 
Remove the fuel cap.
  Insert  a  clean  funnel  into  the  fuel  tank  then  slowly 
pour  gasoline  into  the  tank.  Fill  tank  to  approximately  
1-1/2 in. below the top of the tank neck (this allows for 
fuel expansion).
  Replace fuel cap and tighten until the cap “clicks.”
  Clean up any spills before starting the engine.
STARTiNg  ANd  STOPPiNg  ThE  PRESSURE 
wAShER
See Figures 17 - 18.
cAUTiON:
Do not run the pump without the water supply connected 
and turned on.
Before starting the engine:
 Connect all hoses.
 Check all fluids (lubricant and gas).
 Turn  on  the  garden  hose  then  squeeze  the  trigger  to 
relieve air pressure; hold the trigger until a steady stream 
of water appears.
OPERATiON