Troy-Bilt 10030 Manual De Usuario

12

The space between the shave plate and the ground can 
be adjusted by raising or lowering the skid shoes. 

For close snow removal, as when using on a smooth 
concrete or asphalt driveway, place the skid shoes in 
the low position. Use the middle or high position when 
the area to be cleared is uneven. When operating on 
gravel, always put skid shoes in the high position.
See Figure 11. Adjust skid shoes as follows:

•

Loosen, but do not remove, the three hex nuts 
which fasten the skid shoe to the auger housing.

•

Raise or lower the skid shoe to desired position.

•

Retighten the hex nuts loosened earlier.

•

Repeat on the other side of the snow thrower.

NOTE: Make certain the bottom surface of skid shoe is
flat against the ground to avoid uneven wear .

Refer to Auger Control Test on page 6 to adjust the auger 
control. Make certain to check for correct adjustment 
as instructed before operating the snow thrower.

•

The distance snow is thrown can be adjusted by 
adjusting the angle of the chute assembly. Refer to 
page 8 for instrcutions.

•

The remote chute control cables have been pre-
adjusted at the factory. Move the remote chute 
lever on the control panel back and forward to 
adjust angle of the chute assembly.

•

The wheels may be adjusted for two different 
methods of operation. Follow the steps below for 
adjustment. See Figure 12.

•

On the right side of the unit, place klick pin in the 
outside axle hole only. Do not place pin through 
wheel hub.This position gives power drive to the left 
wheel only, making the unit easier to maneuver.

•

Rotate wheel assembly to align hole in the hub with 
the inner hole on the axle shaft. Insert klick pin in 
the hole. Outer axle shaft hole should be visible.

NOTE:  NEVER operate the snow thrower with the click
pin inserted through both the RIM and the OUTSIDE
HOLE in the axle. Doing so can result in serious
damage to the drive system.