Guardian Technologies 004708-0 Manual De Usuario

 20 

These  Installation Instructions have been prepared 
especially for the purpose of familiarizing installers 
and owners of the applicable equipment with the 
product's installation requirements. Give serious 
consideration to all information and instructions in 
the manual, both for safety and for continued reliable 
operation of the equipment.

Because of the different recreational vehicle mod-
els and the variations between the models, it would 
be extremely difficult, if not impractical, to provide 
detailed instructions for every possible installation. 
For that reason, instructions and illustrations in this 
manual are general in nature. Illustrations are not 
intended to serve as detailed installation blueprints.

The installation should comply strictly with all appli-
cable codes, standards and regulations pertaining 
to the installation and use of this product. If any 
portion of this manual appears to be in conflict with 
such codes, standards or regulations, the applicable 
codes, standards or regulations must take prece-
dence over the manual.

Before handling, installing, operating or servicing this 
equipment, carefully read the “Notice to Installer” 
and “Safety Rules”. Comply with all safety rules to 
prevent death, personal injury or damage to equip-
ment and/or property. Stress safety to all installers, 
operators and service technicians who work on this 
equipment.

Installation, use and servicing of this equipment 
should comply strictly with published standards, as 
well as the manufacturer's recommendations. The 
following standards booklets (latest revision) are 
available from the sources indicated:

1.  NFPA Standard 501C, “Standard for Recreational 

Vehicles,” available from the National Fire 
Protection Association, Batterymarch Park, 
Quincy, MA 02269.

2.  NFPA 70, “NFPA Handbook of the National 

Electric Code,” available same as Item 1.

3.  ANSI C1-1975 and ANSI 119.2-1975, available 

from the American National Standards Institute, 
1430 Broadway, New York, NY 10018.

4.  ANSI A119.2/NFPA 501C, available from the 

Recreational Vehicle Association, 1896 Preston 
White Drive, Reston, VA 22090.

5.  California Administrative Code, Title 25, available 

from the State of California, Documents Section, 
P.O. Box 1015, North Highlands, CA 95660.

6.  CSA Electrical Bulletin 946, available from the 

Canadian Standards Association, Housing and 
Constructions Materials Section, 178 Rexdale 
Boulevard, Rexdale, Ontario, Canada, M9W 1R3.

Instructions and information in this section pertain 
to air-cooled generators. This generator is designed 
specifically for installing in recreational vehicles. This 
generator operates 120-volts, single-phase, 60-Hertz, 
AC electrical loads that require 30.0 amps.

The generator’s revolving field (rotor) is driven by a 
single-cylinder, four-cycle engine. The generator sup-
plies 120 volts AC at 60 Hertz when the rotor is oper-
ating at 3,600 rpm.

The generator is equipped with dual stator power 
windings as shown in Figure 1.1.

The AC connection system on air-cooled genera-

• 

tors uses a GROUNDED neutral.

A separate green ground wire is connected to the 

• 

recreational vehicle’s junction box.

NOTE:

Do NOT connect loads in excess of circuit breaker 
ratings.