Guardian Technologies 004708-0 Manual De Usuario

Descargar
Página de 52
 28 
2.4.2.2   Flexible Fuel Line
Use an approved flexible length of fuel hose between 
the generator fuel inlet connection and rigid fuel 
lines. This prevents breaking of the line caused by 
vibration, shifting, settling or movement. The follow-
ing rules apply:
The flexible hose must comply with SAE J30R7, 
• 
“Standard for Fuel and Oil Hose.” It must be 
approved for use with gasoline and low perme-
ability.
The hose should be at least 6 inches (152 mm) 
• 
longer than is needed to prevent the hose from 
rupturing if the generator shifts or settles.
 2.5   EXHAUST SYSTEM
The generator exhaust system must be safely and 
properly installed. Only approved mufflers and other 
exhaust system parts must be used. A properly 
installed exhaust system must be vapor tight, quiet 
and completely safe.
DANGER
  The generator engine gives off DEADLY carbon 
monoxide gas through its exhaust system. This 
dangerous gas, if breathed in sufficient con-
centrations, can cause unconsciousness or even 
death. Never operate the generator set with 
the vehicle inside any garage or other enclosed 
area. DO NOT OPERATE THE GENERATOR IF THE 
EXHAUST SYSTEM IS LEAKING OR HAS BEEN 
DAMAGED. SYMPTOMS OF CARBON MONOXIDE 
POISONING ARE (a) inability to think coher-
ently; (b) vomiting; (c) twitching muscles; (d) 
throbbing temples; (e) dizziness; (f) headaches; 
(g) weakness; and (h) sleepiness. IF FEELING 
ANY OF THESE SYMPTOMS, MOVE INTO FRESH 
AIR IMMEDIATELY. IF SYMPTOMS PERSIST, GET 
MEDICAL HELP. Do not operate the generator 
until its exhaust system has been inspected and 
properly repaired.
  Never tee the generator engine exhaust pipe 
into the vehicle engine exhaust piping. This 
causes excessive back pressure on the generator 
engine. Also, water from one engine can dam-
age the other engine.
2.5.1 SPARK 
ARRESTOR
 
‹
This spark arrestor assembly meets code and stan-
dard requirements of the U.S. Forest Service. Use 
only mufflers and parts approved by the manufactur-
er. Any person(s) installing an unapproved muffler, or 
an unapproved exhaust system part, or modifying an 
exhaust system in any way that might cause a hazard, 
is liable for any damage, injury or warranty expense 
that might be caused by such unapproved installation 
or modification.
Failure to provide and maintain a spark arrestor may 
be in violation of the law. If this generator is used on 
any forest covered, brush covered or grass covered 
unimproved land, provide a spark arrestor. The vehi-
cle owner or operator must maintain this device in 
good condition. In the state of California, the preced-
ing is required by law (Section 4442 of the California 
Public Resources Code). Other states may have simi-
lar laws. Federal laws apply on federal lands.
When installing/replacing the tailpipe or spark arres-
tor components, verify that the tailpipe has a hole 
to securely fasten the spark arrestor components 
(see Figures 2.11 and 2.12). Use only manufacturer 
supplied hardware. Substitution of parts may cause 
damage to the screen or a loose fit to the tailpipe.
Figure 2.11 - Spark Arrestor
RETAINING 
SCREW P/N 056892
SPARK ARRRESTOR
SCREEN P/N 089680
TAILPIPE
P/N 0E0683
Figure 2.12 — Spark Arrestor Installation
40 [1.58"]
5.5 [7/32"] DRILL
BOTTOM SIDE ONLY
27.4 [1.08"] I.D.
Section 2 – Installation
Recreational Vehicle Generator