Guardian Technologies 004582-2 Manual De Usuario

Descargar
Página de 36
2.6  BEFORE STARTING THE GENERATOR
Prior to operating the generator, engine oil and gasoline will need to 
be added, as follows:
2.6.1  ADDING ENGINE OIL
NOTE:
When adding oil to the engine crankcase in the future, use only 
high quality detergent oil rated with API service classification 
SG, SH or SL SAE 30 weight. Use no special additives.
5 W - 3 0
5 W - 3 0
S y n t h e t i c     5 W - 3 0
S y n t h e t i c     5 W - 3 0
S A E   3 0 ,  1 0 W - 3 0
S A E   3 0 ,  1 0 W - 3 0
Select the oil’s viscosity grade according to the expected operating 
temperature. Do not use SAE 10W-40.
NOTE:
Synthetic oil should only be used after first oil change.
Above 40°F, use SAE 30, synthetic 5W-30 or SAE 10W-30.
Below 40°F, use synthetic 5W-30 or 5W-30.
Although multi-viscosity oils (5W-30, 10W-30, etc.) improve starting 
in cold weather, these multi-viscosity oils will result in increased oil 
consumption when used above 32°F. Check the engine oil level more 
frequently to avoid possible damage from running low on oil.
Place generator on a level surface.
Clean area around oil fill and remove oil fill cap and dipstick.
Wipe dipstick clean.
Slowly fill engine with oil through the oil fill opening until it reaches 
the full mark on the dipstick. Stop filling occasionally to check oil 
level. DO NOT OVERFILL.
Install dipstick. Install oil fill cap and finger tighten securely.
Check engine oil level before starting each time thereafter.





2.6.2 ADDING 
GASOLINE
  Never fill fuel tank indoors. Never fill fuel tank 
when engine is running or hot. DO NOT light a 
cigarette or smoke when filling the fuel tank.
  Do not overfill the fuel tank. Always leave room 
for fuel expansion.
Use regular UNLEADED gasoline with the generator engine. Do 
not use premium gasoline. Do not mix oil with gasoline.
Clean area around fuel fill cap, remove cap.
Slowly add unleaded regular gasoline to fuel tank. Be careful not 
to overfill. Allow about 1/2" of tank space for fuel expansion, as 
shown here (Figure 14).
Install fuel cap and wipe up any spilled gasoline. 
Figure 14 - Fuel Tank
IMPORTANT: It is important to prevent gum deposits from forming 
in fuel system parts such as the carburetor, fuel hose or tank during 
storage. Alcohol-blended fuels (called gasohol, ethanol or methanol) 
can attract moisture, which leads to separation and formation of acids 
during storage. Acidic gas can damage the fuel system of an engine 
while in storage. To avoid engine problems, the fuel system should 
be emptied before storage of 30 days or longer. See the "Storage" 
section. Never use engine or carburetor cleaner products in the fuel 
tank as permanent damage may occur.

10
Section 2 – Operation
Commercial-Industrial-Residential Portable Generator System