Guardian Technologies 04759-2 Manual De Usuario

3.  Wipe away dust or debris from inside of the air 

box and around edges.

4.  Install the new air cleaner into the air box.
5.  Install the cover. Turn the two cover screws clock-

wise to tighten.

See the “Service Schedule,” Section 4.13 for air 
cleaner maintenance. See Section 1.5.1 for air filter 
replacement part number.

Reset the spark plug(s) gap or replace the spark 
plug(s) as necessary. See Section 4.13 for mainte-
nance requirements.

1.  Clean the area around the base of the spark 

plug(s) to keep dirt and debris out of the engine. 
Clean by scraping or washing using a wire brush 
and commercial solvent. Do not blast the spark 
plug(s) to clean.

2.  Remove the spark plug(s) and check the condi-

tion. Replace the spark plug(s) if worn or if reuse 
is questionable. See Section 4.13 for recommend-
ed inspection.

3.  Check the spark plug gap using a wire feeler 

gauge. Adjust the gap to 0.76 mm (0.030 inch) 
for 7 kW and 0.50 mm (0.020 inch) for 12/15 kW 
by carefully bending the ground electrode (Figure 
4.8).

The battery should be inspected per the “Service 
Schedule,” Section 4.13. The following procedure 
should be followed for inspection:

1.  Inspect the battery posts and cables for tightness 

and corrosion. Tighten and clean as necessary.

2.  Check the battery fluid level of unsealed batteries 

and, if necessary, fill with DISTILLED WATER 
ONLY. DO NOT USE TAP WATER IN BATTER-
IES.

3.  Have the state of charge and condition checked. 

This should be done with an automotive-type bat-
tery hydrometer. 





  

19