Generac 005789-0 Manual De Usuario

Remove all packaging material.

• 

Remove separate accessory box.

• 

Remove the generator from carton.

• 

Check all contents. If any parts are missing or damaged, locate an 
authorized dealer at 1-888-436-3722.

1 - Owner’s Manual

• 

1- Oil SAE 30

• 

2- 7” Wheels

• 

1- Handle Assembly

• 

1- Handle Bracket

• 

1- Wheel Axle

• 

1- Hardware Bag (containing the following):

• 

2 - Rubber bumpers 

7 - M6 Flange Nuts

2 - Bumper Brackets 

2 - Cotter Pins

2 - M12 Flat Washers 

2 - Hubs

5 - M6-1 x 40 Flange Bolts 

2 -  M6-1.0 x 16 Flange 

Bolts

The generator requires some assembly prior to using it. If problems 

arise when assembling the generator, please call the Generator 

Helpline at 1-888-436-3722.

The wheels are designed to the unit to greatly improve the 

portability of the generator.

1.  Refer to Figure 1 to install the wheels as shown.

• Slide the axle through the frame brackets.

• Slide on the hub, wheel and flat washer, then insert the 

cotter pin through the wheel axle hole.

• Bend the cotter pin tabs outward to lock the pin in place.

2.  Refer to Figure 1 to install the wheel bumpers as shown.

• Insert an M6 bolt through the rubber bumper and the 

bottom of the bumper bracket. Secure the bolt with an M6 

flange nut. 

• Install an M6 bolt through the generator frame and 

through top of the bumper bracket. Secure the bolt with 

an M6 flange nut.

3.  Refer to Figure 2 to install the handle assembly as shown. 

• Insert the handle bracket onto the generator frame and 

secure with two M6 bolts and two M6 flange nuts.

• Align the handle assembly holes with the handle bracket 

holes and secure with one M6 bolt and one M6 flange 

nut.

this generator.
Compare the generator to Figures 3 through 6 to become 

familiarized with the locations of various controls and adjustments. 

Save this manual for future reference.

1.  120 Volt AC, 20 Amp, GFCI Receptacle – Supplies electrical 

power for the operation of 120 Volt AC, 20 Amp, single-phase, 

60 Hz electrical lighting, appliance, tool and motor loads.

2.  Circuit Breakers (AC) – Each receptacle is provided with a 

13.5A push-to-reset circuit breaker to protect the generator 

against electrical overload.

3. Air Filter – Filters intake air as it is drawn into the engine.