Multiquip CDA45SSIU3 Manual De Usuario

Place the 

1. 

main, G.F.C.I., and aux. circuit breakers (Figure 

35) in the OFF position prior to starting the engine.

Make sure the 

2. 

voltage change-over board has been 

confi gured for the desired output voltage.

Connect the load to the 

3. 

receptacles or the output 

terminal lugs as shown in Figure 10. These load 
connection points can be found on the output terminal 
panel and the output terminal panel’s hard wire hookup 
panel. 

Tighten terminal nuts securely to prevent load wires 

4. 

from slipping out.

Close all engine enclosure doors (Figure 36).

5. 

The engine’s exhaust contains harmful emissions. 
ALWAYS have adequate ventilation when operating. 
Direct exhaust away from nearby personnel.

NEVER manually start the engine with the main, GFCI or 
auxiliary circuit breakers in the ON (closed) position.

INCORRECT

CORRECT

Place the

1. 

 voltage selector switch in the desired 

voltage position (Figure 37)..

Preheat the engine glow plugs by turning the ignition 

2. 

key (Figure 38) to the “OPERATION” position.

When the preheat lamp illuminates (Figure 39), turn the 

3. 

ignition key to the “start” position.  Once the engine 
starts, release the ignition key and allow it to return to 
the “operation” position (Figure 38).

Let the engine run for 3-5 minutes, listen and check 

4. 

for any abnormal sounds or smells. Check for fuel 
leaks, and noises that would associate with a loose 
cover or hardware. If any of the above mentioned 
conditions exists, shut-down the engine and correct 
the problem.