Roland Piano Manual De Usuario
76
Creating a Rhythm Set
Realtime Controller / D Beam
Controller Settings (Controller)
fig.04-11_50
Knob
Assign 1–4 (Realtime Control Knob Assign 1–4)
Specify the functions that will be controlled by the [
]–[
] knobs.
Value
OFF:
The realtime control knob will not be used.
CC01–31, 33–95:
Controller numbers 1–31, 33–95
For more information about Control Change messages, please
refer to
refer to
“MIDI Implementation”
(Sound/Parameter List).
PITCH BEND:
Pitch Bend
AFTERTOUCH:
Aftertouch
TEMPO:
Tempo
PTN ACCENT:
Rhythm Pattern Accent Rate
PTN SHFFLE:
Rhythm Pattern Shuffle Rate
Switch
Assign 1–4 (Realtime Control Button Assign 1–
4)
4)
Specify the functions that will be controlled by the [
]–[
]
buttons.
Value
OFF:
The realtime control button will not be used.
CC01–31, 33–95:
Controller numbers 1–31, 33–95
For more information about Control Change messages, please
refer to
refer to
“MIDI Implementation”
(Sound/Parameter List).
BEND UP:
Raises the pitch in semitone steps (up to 4 octaves
higher).
BEND DOWN:
Lowers the pitch in semitone steps (up to 4 octaves
lower).
AFTERTOUCH:
Aftertouch
OCT UP:
Raises the key range in octave steps (up to 3 octaves
higher).
OCT DOWN:
Lowers the key range in octave steps (up to 3 octaves
lower).
TRNS UP:
Raises the key range in semitone steps (up to 6 semitones
higher).
TRNS DOWN:
Lowers the key range in semitone steps (up to 5
semitones lower).
TAP TEMPO:
Tap tempo (a tempo specified by the interval at which
you press the button).
PTN HOLD:
Switch between Hold On/Hold Off for the Rhythm
pattern playback.
Mode 1–4 (Realtime Control Button Mode 1–4)
Specify how the [
]–[
] buttons are to operate.
Value
MOMENTARY:
The button will be on only while you are pressing
(holding) it, and will be off when you release your finger from the
button.
button.
LATCH:
The button will switch on/off each time you press it.
D Beam
Switch (D Beam Switch)
Switches the D Beam controller on/off.
Value:
OFF, ON
Assign (D Beam Assign)
Specifies the function controlled by the D Beam controller.
Value
OFF:
The D Beam controller will not be used.
CC01–31, 33–95:
Controller numbers 1–31, 33–95
For more information about Control Change messages, please
refer to
refer to
“MIDI Implementation”
(Sound/Parameter List).