Roland XV-5080. Manual De Usuario

1. Turn off the power on the XV-5080 and any connected 

devices, and disconnect any cables connected to the XV-
5080.

2. Detach the cover on the top of the XV-5080.

fig.07-002.e

3. The order in which the slots are used when installing the 

SIMMs depends on the number of SIMMs added. Refer 
to the table below.

Two cards:

A, then B

One card:

A

4. After confirming the position of the SIMM’s notch and its 
orientation, insert the SIMM at an angle into the slot.

5. Using your fingers, push up on the SIMM until it stands 
upright in the slot.

The SIMM is then held in place with the silver-colored 
latches on both sides of the slot.

fig.07-003.e

6. When installing more than one SIMM, repeat Steps 4 and 

5.

7. Return the XV-5080’s top cover to its original position.

This completes installation of the SIMM or SIMMs.

Remove SIMMs in the reverse order of that used for 
installation.

Before beginning this procedure, turn off the power to the 
XV-5080 and all connected devices.

1. Simultaneously push the silver-colored latches on both 

sides of the slot outwards.

The SIMM is released from the latches, and remains in the 
slot, at an angle.

fig.07-004.e

2. Pull the SIMM out of the slot.

1. Press the [SYSTEM/UTILITY] button, getting its 

indicator to light.

2. Press the [F6 (Info)] button.

The SYSTEM Info page will appear.

3. Confirm that the capacity of the SIMM appears next to 

the slot in which it is placed.

Screws to be removed