Roland XV-5080. Manual De Usuario

• Press the corresponding button to turn on the indicator. 

• If the send levels to each effect are at 0, effects will not 

apply. Check each setting. 

• Even if the send level to each effect is above 0, effects 

will not apply if the MFX Output Level, Chorus Level, 
and Reverb Level are set to 0. Check each setting. 

• If Output Assign is set to PATCH for each Part of the 

Performance, the sound will be output according to the 
Output Assign settings of the Patch (for each Tone) 
which is assigned to those Parts. This means that if the 
Output Assign of (each Tone in) the Patch is set to 
PATCH, the MFX sound will not be output.

• Check the settings for the MIDI receive channel and the 

various switches for reception of MIDI messages.

• In order for system exclusive messages to be received, 

the Device ID Number must match that of the 
transmitting device, and the System Exclusive receive 
switch must be on. (p. 212) Also, if you wish to rewrite 
data in the USER group, the System Exclusive message 
Protect Switch must be turned off as well. (p. 205)

• When the DEMOPLAY page is displayed, MIDI 

messages received from an external device will be 
ignored.

• An uninitialized Memory Card cannot be used. Perform 

• It is not possible to read the contents of a card which is 

for the XV-5080. Also, it is not possible to write data to a 
Memory Card which was formatted on a device other 
than the XV-5080.

• The beginning of a GM score song contains a GM System 

On message. In some cases, a GM Score cannot be played 
back correctly unless this message is received.

• Since the XV-5080 is a GM system compatible sound 

source, there may be cases in which GS format song data 
will not playback correctly.

• Read “Turning On the Power” in Quick Start (P. 12), 

then turn on the power to the devices in the correct 
order.

• Should this be the case, set a higher value for the SCSI 

Probe Time (p. 208).First, turn off the XV-5080’s power, 
following the instructions in “Turning Off the Power” in 
Quick Start (P. 12). Then, following the instructions in 
“Turning On the Power” in Quick Start (P. 12), turn on