Edirol SD-80 Manual De Usuario

Descargar
Página de 132
 
12
 
Names of things and what they do
 
 
Rear Panel
 
fig.1-02
 
17
 
AC IN Connector
 
Connect the supplied AC cable here. Never use any AC cable other than the one provided, since doing so 
may cause malfunction.
 
18
 
Grounding Terminal
 
In some cases, depending on the environment in which the unit is installed, the surface of the panel may 
sometimes feel rough and grainy. This is due to an infinitesimal electrical charge, which is absolutely 
harmless. However, if you are concerned about this, connect the ground terminal (see figure) with an 
external ground. When the unit is grounded, a slight hum may occur, depending on the particulars of 
your installation. If you are unsure of the connection method, contact the nearest Roland Service Center, 
or an authorized Roland distributor, as listed on the “Information” page.
 
 
Unsuitable places for connection
 
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod (may be dangerous in the event of lightning)
 
19
 
OUTPUT Jacks
 
These jacks output audio signals to your audio playback system or amplified speakers.
The output destination setting of a part will determine whether its sound is sent to 
 
OUTPUT
 
 jacks 
 
1
 
 or 
 
2
 
Normally, the sound will be sent to the 
 
OUTPUT 1
 
 jacks.
The front panel 
 
VOLUME knob
 
 affects only the 
 
OUTPUT 1
 
 jacks.
 
20
 
DIGITAL OUT Jacks
 
These jacks can be connected to digital audio devices such as CD players and MD players to transfer 
digital audio signals.
Use a coaxial cable for 
 
COAXIAL
 
, and an optical digital cable for 
OPTICAL
.
*
The digital output transmits the OUTPUT 1 signal.
*
The signal that is sent from the SD-80's 
DIGITAL OUT
 jack may be digitally copied for one or more generations.
21
MIDI OUT/THRU Switch
If this is set to 
[IN1 THRU]
, the MIDI messages sent to the 
MIDI IN 1
 connector will be retransmitted 
without change from the 
MIDI OUT 2
 connector.
22
MIDI Connectors
These connectors can be connected to other MIDI devices, such as a sequencer, allowing the exchange of 
MIDI messages (
IN1/IN2
:
These connectors receive MIDI messages from other devices. The received MIDI 
messages are sent to the computer (in USB mode) or to the internal sound generator (in 
MIDI mode).
OUT1/OUT2
:
These connectors transmit MIDI messages to other devices.
23
USB Connector
A USB cable can be used to connect the SD-80 to your computer.
22
19
23
21
20
18
17