Roland MC-09 Manual De Usuario

• Once the connections have been completed (p. 12), turn on power to 

your various devices in the order specified. By turning on devices in the 
wrong order, you risk causing malfunction and/or damage to speakers 
and other devices.

• This unit is equipped with a protection circuit. A brief interval (a few 

seconds) after power up is required before the unit will operate 
normally.

• Turn the volume down before you turn on the power. You may hear 

sound from the headphones when you turn on the power, but this is not 
a malfunction.

Make sure that the volume controls of the MC-09 and all 
connected devices are turned to the minimum position.

Turn on the power of the device connected to the INPUT jacks.

Turn on the power of the MC-09.

Turn on the power of the device connected to the OUTPUT jacks.

Adjust the volume of all devices.

On the MC-09, the volume is affected by three types of knob or control. You 
will need to adjust these as appropriate.

OUTPUT knob:

 This adjusts the overall volume of the MC-09.

LEVEL knob:

 This adjusts the volume from the device connected to

the INPUT jacks and the volume of the DSP 
synthesizer.

Part volume sliders: These adjust the volume of each audio looper part.

To turn off the power, make sure that the volume controls of the MC-09 and 
all connected devices are turned to the minimum position, and turn off the 
power of each device in the opposite order of that used when you turned 
them on.