Samson MDR6 Manual De Usuario

15

ENGLISH

Now that you have recorded a basic rhythm track you can overdub additional tracks using MDR6’s HDM. For this exam-
ple, we’ll overdub a vocal track using a microphone.  Follow the steps below. 

1.   Connect the output from your computer sound card to the MDR6’s 2-Track In and then connect the MDR6’s 2-Track 

Output to the input of the sound card. 

2.   Connect a microphone to the MDR6’s Channel 1 microphone input and set a proper level using the GAIN control 

and peak LED.

3.   Engage the HDM switch. 

4.   Press the RECORD switch on the MDR6’s Channel 1. The input channel’s REC LED will flash indicating the channel is 

assigned to the RECORD bus.

5.   Raise the Channel 1 fader to the nominal area (0 ).  

6.   Now,  test your listening level by pressing PLAY on your hard disk recorder and by slowly 

raising the 2TK LEVELlevel control until you have set a comfortable listening level.  Use 
the 2TK LEVELand CONTROL ROOM/HEADPHONE level controls to set a good balance 
between the hard disk recorder and the input. 

7.   Select the record enable on the track you are recording to on your hard disk recorder and 

set a level as described in your software manual.

8.  Press REC/PLAY on your hard disk recorder and record your vocal track.

NOTE: The RECORD bus is stereo, therefore the input channels PAN and BALANCE controls will 
determine how much signal is sent to the LEFT or RIGHT  
2-TRACK output.  If you want an input channels signal to send only to the LEFT RECORD bus, 
then set the PAN control all the way to the left. If you want an input channels signal to send 
only to the RIGHT RECORD bus, then set the PAN control all the way to the right.

�

�

�

�

�

�

�

�