Euphonix 5B Manual De Usuario

System 5-B Digital Audio Mixing System Operation Manual

 

CM401 Master Section

64

The listen mics can feed any combination of the CR Main, Alt1, Alt2, or Mon A–D 
speakers by activating their keys on the top half of the Panel. Activate Lsn>Flw to route 
the listen mics to the active CR Speaker. 

Activate the DimCR key to dim the CR Speaker by the level set for the DIM key when 
the listen mics are on (see Dim and Cut on page 59).

Turn the listen mics on/off by pressing the 1>Lsn..4>Lsn keys on the left of the Panel. 
Turn all listen mics on/off by pressing the All>Lsn key. The on/off keys are momentary 
unless Lsn Ltch is active.

Set the listen mic levels by pressing one of the Lsn4..Lsn1 xx.x keys on the right of the 
Panel and using the +/- soft keys to set the level.

Press the OscSlt key at the bottom of the Comms:Talkback Panel to display the 
Comms:Slate/Osc Panel (Figure 5-7). 

Turn the oscillator on by activating the Osc>On key. Select the oscillator type by press-
ing the Osc>Sine, Osc>White, or Osc>Pink keys on the top-right of the Panel. These 
keys intercancel so only one type can be selected at a time.

Select the oscillator frequency by pressing the Osc>100Hz, Osc>440Hz, Osc>1kHz, 
or Osc>10kHz keys on the left of the Panel. In addition, there is a user-selectable fre-
quency key below the Osc>10kHz key. Activate this key and use the +/- soft keys to 
set the frequency (20 Hz to 21 kHz). All of the frequency keys intercancel.

Set the oscillator level by activating the Osc>xx.x key (above Osc>Grp) and using the 
+/- soft keys.

Set the Slate frequency by activating the Slt>xx.xH key and using the +/- soft keys.

Set the Slate level by activating the Slt>xx.x key and using the +/- soft keys. 

Activate the Slt>Grp and Slt>Main keys to route the Slate to Group and/or Main sections, 
respectively. Activate the Slt>ALL key to route the Slate to Group and Main sections.