Solid State Logic Soundscape Mixer Manual De Usuario

 
 
 
 

Page 16 of 109 

 

 

Output pan and balance controls 

 
Output pan and balance sliders can be clicked and dragged with the mouse. 
 
It is also possible to change the value in the box, to the right of the slider: 
 
− Right-clicking or left-clicking in the box respectively increases or decreases the value in steps of 
1. 
 
− Right-clicking or left-clicking in the box and holding the mouse button down respectively 
increases or decreases the value continuously. The other mouse button can then be held down as 
well to speed up the process even more. 
 
− Double-clicking in the value box calls up a dialog box where the required value can be entered: 
 
 
 
 
 
 
 
 
− Clicking on the center button below the value box resets the value to 0. 
 

Fader and mute groups, output mute buttons, solo groups and solo buttons 

 
Each output element that has a fader can be assigned to any one of 99 fader groups, and to any one 
of 99 solo groups. This applies regardless of the output type, (mono, stereo, mono to stereo, 4, 6 or 
8 channels, LRCS, or 5.1), as long as there is a fader. Note that a single mixer column could have 
several such outputs, assigned to different fader groups and solo groups. 
 
The fader group and solo group assignments can be selected in several ways: 
 
− Right-clicking or left-clicking in the relevant group assignment selection box respectively 
increases or decreases the value in steps of 1. 
 
− Right-clicking or left-clicking in the selection box and holding the mouse button down 
respectively increases or decreases the value continuously. The other mouse button can then be 
held down as well to speed up the process even more. 
 
− Double-clicking in a selection box calls up a dialog box where the required fader group number 
or solo group number can be entered: