Stanton SCS.4DJ Manual De Usuario

16

The main speed control for your music. This slide, when pushed towards the bottom of the unit 

(+), increases the tempo of playback. When the slide is pushed towards the top of the unit (-), the 

tempo of playback is decreased. Pitch Range is selectable in ranges of +/-5% to +25/-100% from 

the ‘SYSTEM’ menu.

Used to temporarily decrease or increase the playback speed. Pitch will return to the current setting 

when released.

The main control of the internal 

SYNC engine, allowing for one-touch beat matching of your playing 

songs. During playback, pressing this button will change the speed and beat position of the selected 

track to match that of the track playing on the opposing deck. This overrides the 

SLIDER(#5). When the PITCH CONTROL SLIDER is moved again it’s operation depends on the 

value of the Soft Takeover (if the 

PITCH CONTROL SLIDER(#5) responds immediately to your 

movement or after you have moved past the virtual pitch setting) setting in the SCS.4DJ Settings 

menu. If the setting is On (Soft Takeover enabled – default value), Pitch value will not change until 

the 

PITCH SLIDER is moved to match the virtual value of the Pitch set by the SYNC engine. 

The 

AUTO LED at the midpoint of the PITCH CONTROL SLIDE indicates when the two are not 

synchronized, ie: if 

PITCH CONTROL SLIDE and VIRTUAL PITCH POSITION (the pitch position 

chosen by the SYNC engine, regardless of PITCH CONTROL SLIDE position) are not the same. 

The LCD Display also has an arrow displayed next to the TEMPO value indicating which way to 

move the 

PITCH CONTROL SLIDE. If the setting is OFF, (No Soft Takeover) then any movements 

of the 

PITCH CONTROL SLIDE will become effective immediately.

Dual effect processors, one for each deck, and both can be used at the same time. This section 

controls the four on board audio effects 

FILTER, FLANGER, SLICE and DELAY. Using the two 

EFFECT CONTROL knobs, you can individually adjust two effect parameters depending on what 

effect you are in. 

Tap along with the music to enter manual BPM values for use with 

DSP EFFECTS or SYNC 

ENGINE. This is used to manually enter BPMs when the Auto BPM function is unable to lock on a 

beat. You must tap at least four times to enter a new BPM value.