Stanton SCS.4DJ Manual De Usuario

25

4)  If you wish to continue playback while holding the

 CUE button, pressing the PLAY button will 

disengaged the 

CUE button and start the SCS.4DJ to play in normal play mode. Both buttons 

can then be released.

5)  If you wish to create a new 

CUE POINT, press the PLAY/PAUSE button again at the location 

you wish to create the 

CUE POINT at, and press the CUE BUTTON once again. A new CUE 

POINT will be set.

Pressing the 

SYNC button on a deck changes the Pitch to match the BPM of the opposite deck 

and lines up the playback position of the 

BEAT GRID (shown in the diagram on page 28) of the 

song on the other deck. As the tracks play forward, this button can be used again to synchronize 

the tracks back together if they fall off beat for any reason.

To use the 

SYNC button it is necessary that both tracks have BPM values associated with them 

(greater than zero). This value normally comes from when your SCS.4DJ analyzed your tracks, but 

can also come from a tapped BPM value or a BPM value stored with the track data if analysis has 

not yet occurred. 

If the BPM of the two tracks differs too greatly, or the current pitch slider range for the deck is less 

than the needed pitch value change, the pitch is changed to the maximum value allowed by the 

pitch slider, and the play position of the slave deck is jumped to beat align momentarily with that of 

the master deck. If either track is not analyzed or the BPM has been tapped or edited or the deck 

on which 

SYNC is pressed is not playing, the pitch of the deck will be changed but the playback 

position will not jump to be beat aligned.

The SCS.4DJ’s sync engine can match BPM’s based on half or double-timed BPM’s, making it so 

that you can mix tracks with a far-apart BPM value (ie: mixing an 80bpm track with a 160bpm track).

The TAP Button provides a method to correct the automatically generated BPM value.

While the song is playing, Tap the TAP button in time with beats of the music. Multiple taps will set 

the BPM value to the rhythm. The tapped BPM value is the average value of the values tapped in. 

You must tap the TAP button at least four times to set a new BPM. If you wish to defeat the manually 

tapped BPM value, press and hold the TAP button for 2 seconds to reset the detection to SCS.4DJ’s 

AutoBPM value. The new tapped BPM value is then displayed on the screen. 

Please keep in mind that the 

BEAT GRID is not altered with the tapped BPM so the beat grid will 

be out of sync with the new tapped BPM, which can have an adverse effect on the 

SYNC engine 

should SYNC be used. While the TAP function does allow for functions such as 

SYNC to function 

before a song is analyzed, 

LOOP still needs the full song analysis to be completed for the function 

to work.