Stanton PRO.V4 Manual De Usuario
5
16. Power Switch - Turns unit off and on.
17. Power Connector - Plug in the included power supply here.
17. Power Connector - Plug in the included power supply here.
18. Fader Start Control Jacks - Connect these jacks to the Fader input
jacks of the CD player using the 3.5mm stereo mini cord.
19. Master Output - Unbalanced RCA connectors controlled by the
Master level.
20. Line Inputs - Unbalanced RCA jacks for connecting stereo audio
from line level sources such as CD players, HiFi VCRs, cassette
decks, DAT machines, laser discs, tuners, even synthesizers or other
mixing consoles.
Note: Plug mono audio sources into both Left and Right inputs using
Note: Plug mono audio sources into both Left and Right inputs using
a "Y" cable connector.
21. Phono Inputs - Plug your turntables in here. When these connectors
are used, your signal is fed directly to the high-quality RIAA phono
pre-amplifiers. Use this position only for turntables. Line level
sources will overload the sensitive phono preamps and will cause
distortion.
22. GND - Connect each of your turntable ground leads to either of the
two ground terminals.
.
Review this setup diagram. Make sure all faders are at "zero" and all devices are off. First, connect all input sources and processors. Next, connect your
microphone and monitor headphones. Finally, connect the stereo outputs to the power amplifier(s) and/or audio receivers such as tape decks. Plug your
mixer into AC power. Now you are ready to switch everything on.
IMPORTANT: Always switch on your audio input sources, such as turntables or CD players first, then your mixer, and finally any amplifiers. When turning
off, always reverse this operation by turning off amplifiers, then your mixer, and then input devices.
CONTROL OVERVIEW M.212
SETUP M.212
19
18
17
16
20 21 22
DC 6V
TURNTABLE
POWER
SUPPLY
POWER AMP.
C.324.
C.324.
DC 6V