Behringer LX1B Manual De Usuario

BASS V-AMP LX1B/BASS V-AMP PRO LX1B PRO User Manual

The input of the BEHRINGER BASS V-AMP/BASS V-AMP PRO is laid out as a mono 

1/4" TS connector. Line Out, Aux In as well as headphones output are laid out as 

stereo 1/4" TRS connectors. Line outputs can be connected to both balanced and 

unbalanced jacks. The DI OUT connectors of the BASS V-AMP PRO are available 

as balanced XLR connectors. Digital outputs are available as a cinch connector 

(S/PDIF) and XLR connector (AES/EBU). The BNC connector is used to feed in an 

external worldclock signal.

For unbalanced use, pin 1 and pin 3 

have to be bridged

1 = ground/shield

2 = hot (+ve)

3 = cold (-ve)

1

2

3

1

2

3

Fig. 8.1: XLR connections

Fig. 8.2: 1/4" TS connector

For connection of balanced and unbalanced plugs,

ring and sleeve have to be bridged at the stereo plug.

Fig. 8.3: 1/4" TRS connector

Fig. 8.4: Stereo headphones connector

The MIDI standard (Musical Instruments Digital Interface) was first developed 

at the beginning of the ’80s, with the goal of enabling mutual communication 

between electronic instruments of various manufacturers. Over the years, 

the number of possible MIDI applications has increased substantially; 

nowadays, it is perfectly normal to connect entire studios via MIDI.
At the center of this network is a computer with a sequencing software, used to 

control not only keyboards but also effects processors and other peripheral 

equipment. In such a studio, you can control your BASS V-AMP/BASS V-AMP PRO 

in real time from a computer. Using a MIDI footswitch presents itself as a great 

idea, especially in live applications, because it allows you to control not only the 

effects but also selects the presets. 
Your BASS V-AMP/BASS V-AMP PRO is equipped with  standard 5-prong DIN 

MIDI connectors. To connect your unit with other MIDI equippment, you will 

need a MIDI cable. Pre-packed cables available at stores are usually used for 

this purpose. 
MIDI IN: Used to receive MIDI control data. The MIDI channel is set up in EDIT 

mode by pressing the A key and subsequently using the arrow keys.
MIDI OUT/THRU: MIDI OUT lets you send data to another computer or another 

piece of MIDI equipment. Preset data as well as parameter changes are 

transmited. When you reroute the connector to MIDI THRU, your BASS V-AMP/

BASS V-AMP PRO sends no MIDI data of its own; instead, it merely forwards the 

data received at MIDI IN (see chapter 2.1,  

(8)

  A).

8.4.1  Receiving/sending MIDI-Sysex data
The BASS V-AMP/BASS V-AMP PRO can receive a SysEx dump from another MIDI 

unit as long as MIDI function in EDIT mode is activated (A key). However, this also 

automatically overwrites all BASS V-AMP/BASS V-AMP PRO presets. You can also 

send MIDI data to another MIDI device (total dump). While in EDIT mode, keep the 

MIDI key pressed until you get “d” shown in the display. Sending a “total dump“ 

lets you transfer the entire memory contents to another MIDI sequencer and save 

it there. 
It is also possible to send just one selected preset to another MIDI device: 

switch into EDIT mode by simultaneously pressing both arrow keys on the 

sending device, activate the MIDI function and tap the MIDI key briefly. 

Preset information are then located in the temporary buffer, and can be saved 

at a desired preset location.