Roland TD-9 Manual De Usuario
50
Optimizing the pad settings (Trigger parameters)
Connections
Settings
1. Make sure that the VH-11 is correctly connected to
the TD-9.
2. Set up the hi-hat, take your foot off the pedal, and
power-on the TD-9.
* It will be impossible to make the adjustment correctly if the
hi-hat is touching the motion sensor when you turn on the
power.
power.
3. Loosen the clutch screw, and allow the hi-hat to rest
naturally on top of the motion sensor unit.
4. Press [SETUP]-[F1] (TRIG).
The “TRIGGER TYPE” screen will appear.
5. Use [CURSOR] to move the cursor to “H” (HI-HAT).
6. Use [+/-] or [VALUE] to choose “VH11.”
7. Press [F3] (ADVNCD)-[F3] (HI-HAT).
The following screen will appear.
8. Verify the TD-9’s setting.
9. While you watch the meter that’s displayed in the
right side of the screen, turn the VH-11’s VH offset
adjustment screw to adjust it.
adjustment screw to adjust it.
Adjust the screw so that the black
appears in the
meter.
10. Adjust other parameters as needed.
If you don’t set up the VH-11 correctly, it may not operate
correctly. For details, refer to the VH-11 owner’s manual.
correctly. For details, refer to the VH-11 owner’s manual.
Connecting the VH-11 and making settings on the TD-9
TRIGGER
OUT jack
Connect the
HH cable
Connect the
HHC cable
CONTROL
OUT jack
Motion sensor
unit
Parameter
Value
Hi-Hat Type
VH11
VH Offset
Adjustment
Screw
OPEN
CLOSE
VH Offset Adjustment Points
If the closed hi-hat sound is difficult to attain, rotate the VH
offset adjustment screw towards “CLOSE.”
If the open hi-hat sound is difficult to attain, rotate the
screw towards “OPEN.”
offset adjustment screw towards “CLOSE.”
If the open hi-hat sound is difficult to attain, rotate the
screw towards “OPEN.”
If the sound cuts off when you strike the hi-hat
forcefully, rotate the VH Offset adjustment screw
towards “OPEN.”
forcefully, rotate the VH Offset adjustment screw
towards “OPEN.”
TD-9_e.book 50 ページ 2008年1月23日 水曜日 午後4時24分