Bushnell 78-9470 Manual De Usuario
STANDARD EQUIPMENT
•
Refractor Telescope Assembly
•
Exclusive Metal Easy Track® Mount
•
Variable Height-Aluminum Tripod
•
Exclusive Penta Mirror Assembly
•
Revolutionary ZOOM Eyepiece, 8mm, and 15mm
focal length - Eyepieces.
•
Red Dot Finderscope
•
Accessory Tray
•
2.5x Barlow
•
Hardware Packet—(3) Tripod Bolts with Wing Nuts,
(3) Short Accessory Tray Bolts with Wing Nuts, (3)
Tripod Leg Lock Screws
Tripod Leg Lock Screws
TELESCOPE ASSEMBLY
1.
Remove all components from the carton and identify all components. It is a good idea to lay
all the parts out in front of you before assembly. READ THROUGH ASSEMBLY INSTRUCTION
BEFORE YOU ASSEMBLE YOUR TELESCOPE.
all the parts out in front of you before assembly. READ THROUGH ASSEMBLY INSTRUCTION
BEFORE YOU ASSEMBLE YOUR TELESCOPE.
The only tool required in setting up your
telescope is a slotted or Phillips blade screwdriver. Since your telescope is a precision
optical system the parts require careful handling--particularly the telescope, eyepieces, and
various accessory lenses.
optical system the parts require careful handling--particularly the telescope, eyepieces, and
various accessory lenses.
2.
Set-Up Tripod
•
Select one tripod leg. Loosen
Tripod Leg Lock Screw (9)
and extend the
Tripod Leg Middle Section
(6).
For a moment, do not extend the leg fully...a shorter leg is less awkward to work with during
set-up. Tighten the
Tripod Leg lock Screw
so that the
Middle Section
is securely in place. Repeat
for the remaining two legs.
3.
Attach Telescope and Finderscope
•
Note: Before assembling tripod legs to
Easy Track® Mount,
make sure the
Accessory Tray Braces (7) face inward.
Loosen long bolts at the top of
Tripod Leg (5).
Position the
mount over the
Tripod Leg
as shown
(fig. 2).
and secure
Easy Track® Mount
to
Tripod Leg
. Repeat on the
remaining two
Tripod Legs
. Once you have attached all
Tripod Legs
to the mount, securely tighten all wing nuts in
place
.
•
Locate the pre-assembled
Telescope Main Tube (2)
.
Remove
Main Tube Locking Nuts (3)
from screws
extending from bottom of
Telescope Main Tube (2).
Insert
extended screws into holes in cradle of
Easy Track®
Mounting System.
Refasten
Main Tube Locking Nuts (3).
•
Remove plastic insert on bottom side of finderscope to
allow battery to make connection with battery contact for
power. Turn power switch on. See finderscope page.
power. Turn power switch on. See finderscope page.
•
Look through main telescope tube at low power and establish a well-defined stationary target.
Looking through red dot finderscope, alternate tightening each adjustment wheel (at rear and left
side of finderscope) until the red dot of finderscope is precisely aligned and centered on the same
object being viewed in main telescope tube. See finderscope page.
side of finderscope) until the red dot of finderscope is precisely aligned and centered on the same
object being viewed in main telescope tube. See finderscope page.
Fig. 1
Fig. 2